Grizzly H0596 User Manual
Download Instruction sheet of Grizzly H0596 Sander for Free or View it Online on All-Guides.com.
1
2
3
4
Introduction
This 25,000 RPM air belt sander requires 90 PSI,
4 CFM, and
3
/8" x 13" sanding belts. Four-pack
sanding belts (Model H2322) can be purchased
separately for the Model H0596.
Inventory
A. Air Belt Sander ........................................... 1
B.
3
/8" x 13" Sanding Belts .............................. 2
C. Hex Wrench 3mm ...................................... 1
MODEL H0596
AIR BELT SANDER
INSTRUCTION SHEET
Figure 2. Loosening cap screw and hex nut.
Figure 1. Model H0596.
COPYRIGHT © MAY, 2006 BY GRIZZLY INDUSTRIAL, INC.
WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
#BL8253 PRINTED IN TAIWAN
Adjusting Platen and Attaching Belt
To adjust the platen:
1. Using the hex wrench, loosen the cap screw
and hex nut shown in
Figure 2 and turn the
platen to the desired operating angle.
3. Tighten the cap screw and hex nut loosened
in Step 1.
Figure 3. Squaring mounting surfaces.
A
B
C
2. Make sure the platen and housing surfaces
(Figure 3A) are seated and flush with one
another. If these mounting surfaces are not
square, remove the platen from the housing
(Figure 3B) and reseat the platen and clamp
nut.
Platen
Clamp
Nut
A B
Platen
Housing
Mounting Surfaces
EYE INJURY HAZARD!
Always wear safety glasses
when using this tool to
prevent serious personal
injury.
INJURY HAZARD!
Always disconnect tool from
air to prevent unexpected
operation during service.
DUST HAZARD!
Always wear respirator when
using this tool.