Panasonic KX-NT265 Quick Reference Manual

Download Quick reference manual of Panasonic KX-NT265 IP Phone, Telephone for Free or View it Online on All-Guides.com.

Panasonic KX-NT265 Quick reference manual - Page 1
1
Panasonic KX-NT265 Quick reference manual - Page 2
2
Panasonic KX-NT265 Quick reference manual - Page 3
3
Panasonic KX-NT265 Quick reference manual - Page 4
4
Panasonic KX-NT265 Quick reference manual - Page 5
5
Panasonic KX-NT265 Quick reference manual - Page 6
6
Panasonic KX-NT265 Quick reference manual - Page 7
7
Panasonic KX-NT265 Quick reference manual - Page 8
8
Panasonic KX-NT265 Quick reference manual - Page 9
9
Panasonic KX-NT265 Quick reference manual - Page 10
10
Panasonic KX-NT265 Quick reference manual - Page 11
11
Panasonic KX-NT265 Quick reference manual - Page 12
12
Panasonic KX-NT265 Quick reference manual - Page 13
13
Panasonic KX-NT265 Quick reference manual - Page 14
14
Panasonic KX-NT265 Quick reference manual - Page 15
15
Panasonic KX-NT265 Quick reference manual - Page 16
16
IP Proprietary Telephone
Quick Reference Guide
Model No.
KX-NT265
Important Information
When using the KX-NT265, keep the following conditions in mind.
If the unit does not operate properly, disconnect the unit from the Ethernet cable and
then connect again.
If you are having problems making calls, unplug the Ethernet cable and connect a known
working IP Proprietary Telephone (IP-PT). If the known working IP-PT operates properly,
have the defective IP-PT repaired by an authorized Panasonic Factory Servicenter.
If the known working IP-PT does not operate properly, check the Hybrid IP-PBX and the
Ethernet cable.
Wipe the unit with a soft cloth. Do not clean the unit with abrasive powders or with
chemical agents such as benzene or thinner.
Use only the correct Panasonic handset.
Do not disassemble this unit. Dangerous electrical shock could result.
The unit must only be disassembled and repaired by qualified service technicians.
If damage to the unit exposes any internal parts, immediately disconnect the cable or cord.
If the power is supplied from the network to the IP-PT [Power-over-Ethernet], disconnect
the Ethernet cable. Otherwise, disconnect the AC adaptor cord. Then return this unit to
a servicenter.
Never attempt to insert wires, pins, etc. into the vents or other holes of this unit.
Please read other important information on pages 13-15 before use.
WARNING:
TO PREVENT POSSIBLE FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE.
THIS HANDSET EARPIECE IS MAGNETIZED AND
MAY RETAIN SMALL FERROUS OBJECTS.
UNPLUG THIS UNIT FROM POWER OUTLET/THE ETHERNET CABLE IF IT EMITS
SMOKE, AN ABNORMAL SMELL OR MAKES UNUSUAL NOISE.
THESE CONDITIONS CAN CAUSE FIRE OR ELECTRIC SHOCK. CONFIRM THAT
SMOKE HAS STOPPED AND CONTACT AN AUTHORIZED SERVICENTER.
IMPORTANT NOTICE:
• Under power failure conditions, the IP-PT may not operate. Please ensure that a separate
telephone, not dependent on local power, is available for use in remote sites in case of
emergency.
• For information regarding network setup of the IP-PT such as IP address, please refer to
the Installation Manual for the Panasonic Hybrid IP-PBX.
• If an error message is shown on your display consult the network administrator.
• The firmware of the KX-NT265 is protected by copyright laws and international treaty
provisions, and all other applicable laws. It cannot be reverse engineered, decompiled or
disassembled.
Document Version: 2006-04