• Home
• Brands
• Haier Manuals
• Haier HPIM25S
• HAIER HPIM25S User Manual

HAIER HPIM25S User Manual

Download Operation & user’s manual of Haier HPIM25S Ice Maker for Free or View it Online on All-Guides.com. This version of Haier HPIM25S Manual compatible with such list of devices, as: HPIM25S, HPIM25SS, HPIM26S, HPIM26W

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

28

29

30

31

32

33

34

35

36

37

38

39

40

9

English

Operating Process

1. Water is pumped from the water storage tank to the water box, which may

take up to 1 minute.

2. The icemaking cycle begins when the evaporator rods are dipped into the

water box. You will hear the compressor working.

3. It will take approximately 5-13 minutes for each icemaking cycle, depending

on the size selected. The larger the size, the more time is needed to make the

ice. After the cycle is finished, the water box will tilt forward and the

remaining water will flow back into the water storage tank. The evaporator

rods will then release the ice cubes.

Note: If the room ambient temperature is below 60˚ F, then small ice cube

sizes are suggested to prevent ice cubes from fusing together.

4. Approximately 60 seconds later, the water box will tilt backwards and the ice

pusher will push the ice into the ice storage basket. After the water box flips

back to its original position, the next icemaking cycle will begin.

5. When the maximum capacity of ice cubes is collected and the ice reaches the

temperature sensor, the icemaker will automatically stop operating. The “ICE

FULL” LED indicator will light up.

If more ice is needed, remove the ice from the ice storage basket; then

replace the basket into the machine, making sure that the basket is placed

back to its original position. Note: When replacing the basket, ensure that the

temperature sensor is above the basket so that the machine operates properly.

6. To continue making ice, check that there is water in the water storage tank. If

there is no water in the water storage tank, then no water will be pumped into

the water box, and the operation will stop. The "Add Water" LED display will

light up. Press the “OFF” button. Fill the water storage tank with water, and

then press the “ON” button for the icemaker to begin operating again. Allow

the refrigerant inside the compressor at least 3 minutes to settle before

restarting.

7. If the compressor stops for any reason such as water shortage, too

much ice, power off, etc., do not restart the machine right away.

Wait at least 3 minutes before restarting the machine.