Sony FDA-EV1S Manual
Download Operating instructions of Sony FDA-EV1S Digital Imaging Accessories for Free or View it Online on All-Guides.com.
Brand: Sony
Category: Digital Imaging Accessories
Type: Operating instructions for Sony FDA-EV1S
Pages: 2 (0.53 Mb)
1
2
/Operating Instructions/Mode d’emploi/
Manual de instrucciones/
© 2011 Sony Corporation Printed in Japan
4-295-955-01(1)
FDA-EV1S
1
2
3
4
5
6
7
1
2
FDA-EV1S
2
1
2 FINDER/LCD
3
4
5
6
7
OFF
1
2
2
LOCK
ON
FINDER/LCD
FINDER/LCD
2
99.99%
26.2 mm 34.5 mm 40.4 mm
26 g
EL
1.3 cm 0.5
2 359 296
100
1.09 50mm
-1m
-1
23 mm
21 mm -1m
-1
-4.0 m
-1
+1.0 m
-1
1 1
1 1
1
FDA-EV1S
For the customers in the U.S.A.
is device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) is device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
CAUTION
You are cautioned that any changes or modications not
expressly approved in this manual could void your authority
to operate this equipment.
NOTE:
is equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. ese limits are designed to provide
reasonable protection against harmful interference in a
residential installation. is equipment generates, uses, and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment o and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit dierent
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
For the customers in Canada
is Class B digital apparatus complies with Canadian ICES-
003.
e FDA-EV1S (referred to below as “this unit”) can only
be used with a Sony Interchangeable Lens Digital Camera
(referred to below as “camera”) with a Smart Accessory
Terminal 2. is unit does not support Smart Accessory
Terminal.
ese cameras are not available in all countries/regions.
WARNING
Keep out of reach of small children to prevent accidental
swallowing.
To reduce re or shock hazard, do not expose the unit to rain
or moisture.
CAUTION
To avoid injury, be careful not to drop this unit.
Careless handling can lead to injury.
Identifying the Parts
1 Eyepiece sensors
2 FINDER/LCD button
3 Lock screw
4 Eyepiece lens
5 Eyepiece cup
6 Diopter-adjustment lever
7 Connector protect cap
Attaching this Unit
Before attaching this unit
Set the power of the camera to OFF.
Remove the connector protect cap from this unit.
To attach this unit
1 Turn o the power of the camera. Align the
connector of this unit with the Smart Accessory
Terminal 2 on the camera and attach this unit.
2 Rotate the lock screw of this unit to the LOCK
direction.
To detach this unit
Turn o the power of the camera and then detach this
unit by following the attaching procedure in reverse.
To remove the eyepiece cup, pinch in both sides and pull
it rmly. (See illustration )
To attach the eyepiece cup, press it until it clicks.
Using this unit
Set the power of the camera to ON.
Look into this unit and adjust the diopter-adjustment lever
till the display appears clearly in this unit.
When you look into this unit, the image is displayed in this
unit due to the action of the eyepiece sensors. When you
move your face from this unit, the image display returns to
the LCD monitor of the camera.
Press the FINDER/LCD button of this unit to switch the
display between this unit and the LCD monitor on the
camera.
Depending on the status of use, the eyepiece sensors may be
activated so no images appear on the LCD monitor of the
camera. If this happens, press the FINDER/LCD button of
this unit.
Notes on Use
Do not touch the eyepiece lens or connector of this unit.
You cannot use this unit together with an external ash or
other device attached to the camera by the Smart Accessory
Terminal 2.
Be careful not to subject this unit to mechanical shock
while attaching it.
Do not hold the camera only by this unit.
When carrying this unit, remove it from the camera
rst. Attach the connector protect cap to this unit.
Then put it in the supplied carrying pouch.
If you wear glasses and have diculty in viewing in this
unit, you can remove the eyepiece cup from this unit.
e display on the LCD monitor of the camera may dier
from the display in this unit because of the dierence of
their display sizes.
For details about the screen indicator of this unit and how
to set it with a camera, refer to the Instruction Manual of
your camera.
You can change the angle of this unit depending on the
situation of use.
e LCD monitor and electronic viewnder are
manufactured using extremely high-precision technology
so over 99.99% of the pixels are operational for eective use.
However, there may be some tiny black points and/or bright
points (white, red, blue or green in color) that constantly
appear on the LCD monitor and electronic viewnder.
ese points are normal in the manufacturing process and
do not aect the images in any way.
Do not keep the eyepiece lens pointed toward the sun or
other bright light source.
is unit may become warm aer extended use. is is not
a malfunction.
Depending on the surrounding lighting conditions or scene,
the movement of the subject may be jerky, or ickering or
moiré patterns may appear in this unit. ese do not aect
the recorded image in any way.
Do not disassemble this unit or its performance
cannot be guaranteed.
When using this unit outside, be careful not to get it wet
with rain or seawater.
Cleaning this unit
Wipe o any dust from the surface of this unit lightly with a
so clean cloth.
Brush o any dust from the eyepiece lens with a blower
brush and wipe it lightly with a so clean cloth. (Use of a
cleaning cloth is recommended.)
/
Electronic Viewnder/
Viseur électronique/
Specications
Dimensions (Approx.)
(w/h/d)
26.2 mm × 34.5 mm × 40.4 mm
(1 1/16 in. × 1 3/8 in. × 1 5/8 in.)
Mass
Approx. 26 g (0.9 oz.)
(excluding the eyepiece cup and
projecting parts)
Type
Electronic viewfinder
(Organic Electro-Luminescence)
Screen size
1.3 cm (0.5 type)
Total number of dots
2 359 296 dots
Frame coverage
Approx. 100%
Magnification
1.09 × with 50 mm lens at infinity,
–1 m
–1
(diopter)
Eye Point
Approximately 23 mm from the
eyepiece, 21 mm from the eyepiece
frame at –1 m
–1
Dioptor Adjustment
–4.0 m
–1
to +1.0 m
–1
(diopter)
Included items
Electronic viewnder (1), Eyepiece cup (1), Connector protect
cap (1), Carrying pouch (1), Set of printed documentation
Design and specications are subject to change without notice.
is a trademark of Sony Corporation.
À l’intention des clients aux É.-U.
Cet appareil est conforme à la Partie 15 de la réglementation
de la FCC des États-Unis. Son utilisation est sujette aux deux
conditions suivantes :
(1) Cet appareil ne doit pas générer d’interférences nuisibles et
(2) il doit être en mesure d’accepter toute interférence reçue, y
compris les interférences pouvant générer un fonctionnement
indésirable.
AVERTISSEMENT
Par la présente, vous êtes avisé du fait que tout changement
ou toute modication ne faisant pas l’objet d’une autorisation
expresse dans le présent manuel pourrait annuler votre droit
d’utiliser l’appareil.
REMARQUE:
L’appareil a été testé et est conforme aux exigences d’un
appareil numérique de Classe B, conformément à la Partie 15
de la réglementation de la FCC.
Ces critères sont conçus pour fournir une protection
raisonnable contre les interférences nuisibles dans un
environnement résidentiel. L’appareil génère, utilise et peut
émettre des fréquences radio; s’il n’est pas installé et utilisé
conformément aux instructions, il pourrait provoquer des
interférences nuisibles aux communications radio.
Cependant, il n’est pas possible de garantir que des
interférences ne seront pas provoquées dans certaines
conditions particulières. Si l’appareil devait provoquer des
interférences nuisibles à la réception radio ou à la télévision,
ce qui peut être démontré en allumant et éteignant l’appareil,
il est recommandé à l’utilisateur d’essayer de corriger cette
situation par l’une ou l’autre des mesures suivantes :
Réorienter ou déplacer l’antenne réceptrice.
Augmenter la distance entre l’appareil et le récepteur.
Brancher l’appareil dans une prise ou sur un circuit diérent
de celui sur lequel le récepteur est branché.
Consulter le détaillant ou un technicien expérimenté en
radio/téléviseurs.
Pour les clients au Canada
Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
Le FDA-EV1S (appelé ci-dessous « cet article ») ne peut être
utilisé qu’avec un appareil photo à objectif interchangeable
Sony (appelé ci-dessous « l’appareil photo ») à connectique
pour accessoires 2. Ce n’est pas possible avec la connectique
pour accessoires.
Ces appareils photo ne sont pas commercialisés dans tous les
pays/régions.
AVERTISSEMENT
Pour éviter toute ingestion accidentelle, rangez cet article hors
de portée des enfants.
An de réduire les risques d’incendie ou de décharge
électrique, n’exposez pas cet appareil à la pluie ou à l’humidité.
ATTENTION
Pour éviter toute blessure, faites attention de ne pas laisser
tomber cet article.
Un mauvais maniement peut entraîner des blessures.
Identication des éléments
1 Capteurs d’oculaire
2 Touche FINDER/LCD
3 Vis de verrouillage
4 Lentille d’oculaire
5 Oculaire de visée
6 Levier de réglage dioptrique
7 Capuchon de protection de connecteur
Fixation de cet article
Avant de xer cet article
Mettez l’appareil photo en position OFF.
Retirez le capuchon de protection de connecteur de cet
article.
Pour rattacher cet article
1 Éteignez l’appareil photo. Alignez le connecteur de
cet article sur la connectique pour accessoires 2 de
l’appareil photo et rattachez cet article.
2 Tournez la vis de verrouillage de cet article dans le
sens de LOCK.
Pour détacher cet article
Éteignez l’appareil photo et détachez cet article en
procédant à l’inverse de la xation.
(Suite à la page arrière)