• Home
• Brands
• Haier Manuals
• Haier 50FREE-3B
• Haier 50FREE-3B User's Manual

Haier 50FREE-3B User's Manual

Download Operation & user’s manual of Haier 50FREE-3B Washer for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

1.Open the top lid of the washing machine.

2.Put the inner cover component on the outer tub cover, aiming the inner cover

shaft to the installation hole of the corresponding outer tub cover shaft groove.

3.Firstly insert the inner cover shaft of one side into the corresponding outer tub

cover shaft groove, then push the another inner cover shaft into the corresponding outer

tub cover shaft groove. Please install to designated position to guarantee there are no

dropping or abnormal sound in opening and closing of the inner cover, and the operation

shall be smooth. Do not dismount the inner cover component after washing.

Outer tub cover

Outer tub cover shaft groove

Inner cover shaft

Inner cover component

Figure 1

Right hand

Left hand

Figure 2

The washing machine shall be more than 20mm away from the wall.The largest allowed

slope of the supporting base of the machine is 2 . The slanting or rough ground will

result in unstable running or stoppage of the machine. Please adjust it with following

methods:

Confirm it's horizontal:

Adjust the adjustable foot:

Hang the lead line to confirm if it is horizontal.

Adjust the installation position

Loosen Fasten

High

Low

adjustable nut

adjustable foot

Installation and adjustment

Please install and adjust the machine according to the requirement of the manual. It is

very important to your security and correct operating the machine.

1.To twist the adjustable foot, please first

lift up the side of the foot slightly, loosen

the adjustable nut, and twist the foot.

2.Fasten the nut after adjustment.

Install the bottom plate

After you open the package, please lean the washing

machine gently down on softitems ( like the towel cloth,

blanket, etc. ). Install the bottom plate to the bottom of

the machine with the eight screws by a cross screwdriver,

then lift the machine up gently. See to the figure:

soft items

Bottom plate

Screw

Back

Front

Page 9

Page 10

WATER LEVEL

After switching on the power, the washing machine will set to common program including"wash, rinse,

spin "automatically.To select other procedures, push the " WASH"," RINSE"or "SPIN"

button to select the

time of wash and spin, and the times of rinse. After switching on the power,if you push one of the

button among "RINSE"and"

SPIN

the digitron of the former procedures will turn off automatically. The

former procedures will not run. For instance: after switchingon the power. If you push the "SPIN" button

first, it will execute spin singly after starting.

Even there's no water in the tub, a certain period is

required before spin starting.

Separate the laundries that are not colorfast from

other laundries in washing.

Do not use the HEAVY program for the woollen textiles.

The pulsator will not rotate unless the water is

filled to water level .

Attention

After the machine starts operation, you can set the program and procedure during washing,

set spinning time during rinsing but can not make setting in other cases.

Press " WATER LEVEL "button,

select suitable water level

After switching on the power, select a suitable water level to detect the cloth. To select other water level.Refer

to "water level, water quantity and desoge of powder"in Page 9 and "WATER LEVEL/DISINFECT"button in Page

10 for the selection.

4

13

Install the inner cover