Haier HLM-32B Instruction Manual
Download Instruction manual of Haier HLM-32B Water Dispenser for Free or View it Online on All-Guides.com.
Brand: Haier
Category: Water Dispenser
Type: Instruction manual for Haier HLM-32B
Pages: 7 (0.42 Mb)
1
2
3
4
5
6
7
use a large container).
� Then, drain any water left in the tanks by opening the backside hot water drainage
hole cap, until all water drains completely. After that, screw up the cap tightly.
� Put the bottled purified or other dean water on the top cover one minute.
� Push water faucet buttons to insure water flows from both faucets.
� Plug dispenser again into the electrical outlet.
� Now you are ready to use your water dispenser.
NOTE:
NOTE:
NOTE:
NOTE: Your water dispenser has been cleaned and sanitized before leaving the factory,
but in case a taste problem develops, place two tablespoons of baking soda and add tap
water. Fill water tank again and repeat basic operations, except turn hot water function
“ OFF ” to avoid leaving residues in hot water tank.
OPERATION
OPERATION
OPERATION
OPERATION
� Ambient temperature: 10 ~ 42 ℃
� Atmosphere 86 ~ 106kpa
� When using the bottles holding ultra-pure water, distilled water or space water with
the so-called clever lid, tear off the hygienic label on the lid, place the bottles at the
intake, then the core of water guard will automatically open the valve and seal it in
the meantime, when moving the bottles, the valve will also seal automatically to
avoid any possible oozing.
� Push the hot water faucet, bubbles are generated inside the bottle, indicating that
water is flowing into hot water and cold water tanks, keep pressing the hot water
valve until water flows out, dispensing cold water required need no particular
adjustment.
� Do not connect the electrical power plug, until water comes out of the hot water
faucet.
� After plug, the yellow LED indicator will be on indicating the power is “ ON ” .
� Turn on the heating switch, the red LED indicator will be on and the heating system
starts working. When the hot water comes up to 85-95
℃
or so, the red light goes off,
the heating system stops working. The machine turns to the warm-keeping status.
When the hot water temperature is lower than 80
℃
,the heating system will resume
working automatically.
� Turn on the cooling switch, the green LED indicator will be on and the cooling system
starts working. When the cold water falls down to 6-10
℃
, the green light goes off, the
cooling system stops working. The machine turns to the cold-keeping status. When
the cold water temperature goes up to a set degree, the cooling system will resume
working automatically.
� Since the temperature has already been adjusted before leaving the factory, it is
unnecessary for customers to set the temperature.
� Turn the heating and cooling switches on. Then the heating and cooling processes
start working together.
� If the device is not applied for a long time, after the hot water cools down, please
remove the power plug and revolve the drain cap to drain the rest water in the hot
tank then tighten the cap. Open the cold water faucet to drain the rest water in the
cold tank.
� If there is no water flowing from cooling faucet, please shut down the cooling switch
until there is water flowing out.
� If you do not plan to use the water heating function for more than three days, we