• Home
• Brands
• Acer Manuals
• Acer AcerPower 3000
• Acer Power 3000 User Manual

Acer Power 3000 User Manual

Download Operation & user’s manual of Acer AcerPower 3000 Motherboard for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

26

27

System Board 1-27

1.18.3 Correcting Error Conditions

As a general rule, the "Press F1 to continue" error message is caused

by a configuration problem which can be easily corrected. An

equipment malfunction is more likely to cause a fatal error, i.e., an

error that causes complete system failure.

Here are some corrective measures for error conditions:

1. Run Setup. You must know the correct configuration values for

your system before you enter Setup, which is why you should

write these values down when the system is correctly configured.

An incorrect Setup configuration is a major cause of power-on

error messages, especially for a new system.

2. Remove the system cover according to the directions in the

system housing installation guide. Check that the system board

and any expansion boards are set correctly.

3. If you cannot access a new disk, it may be because your disk is

not physically formatted. Physically format the disk using the

FDISK and FORMAT commands.

4. Check that all connectors and boards are secure. Consult the

system housing installation guide for assistance.

If you follow the corrective steps above and still receive an error

message, the cause may be an equipment malfunction.

If you are sure that your configuration values are correct and your

battery is in good condition, the problem may lie in a damaged or

defective chip. Contact an authorized service center for assistance.