• Home
• Brands
• Healthrider Manuals
• Healthrider H 300 HREL3226.0
• Healthrider H 300 HREL3226.0 User's Manual

Healthrider H 300 HREL3226.0 User's Manual

Download Operation & user’s manual of Healthrider H 300 HREL3226.0 Home Gym, Other for Free or View it Online on All-Guides.com.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

15

Inspect and properly tighten all parts of the elliptical

exerciser regularly. Replace any worn parts immedi-

ately. The elliptical exerciser can be cleaned with a

soft cloth and mild detergent. Do not use abrasives

or solvents. To prevent damage to the console, keep

liquids away from the console and keep the console

out of direct sunlight.

When storing the elliptical exerciser, remove the bat-

teries from the console. Keep the elliptical exerciser in

a clean, dry location, away from moisture and dust.

CONSOLE TROUBLESHOOTING

If the console does not function properly, the batteries

should be replaced. To replace the batteries, see

assembly step 8 on page 8.

HANDGRIP PULSE SENSOR TROUBLESHOOTING

If the handgrip pulse sensor does not function proper-

ly, make sure that your hands are positioned as

described in step 5 on page 12. Be careful not to

move your hands excessively or to squeeze the metal

contacts too tightly. For optimal performance, clean

the metal contacts using a soft cloth; never use alco-

hol, abrasives, or chemicals to clean the contacts.

HOW TO ADJUST THE REED SWITCH

If the console does not display correct feedback, the

reed switch should be adjusted. First, remove all of the

screws from both side shields; there are three sizes

of screws in the side shields—note which size of

screw you remove from each hole.

Next, locate the Reed Switch (47). Turn the Flywheel

(48) until the Magnet (53) is aligned with the Reed

Switch. Loosen, but do not remove, the indicated M4 x

16mm Screw (60). Slide the Reed Switch slightly clos-

er to or away from the Magnet, and then retighten the

Screw. Rock the Flywheel forward and backward just

enough that the Magnet passes the Reed Switch

repeatedly. Repeat until the console displays correct

feedback. When the Reed Switch is correctly adjusted,

reattach the side shields. Note: If you have questions

regarding which screw should be in which hole, see

EXPLODED DRAWING B on page 19 and the PART

LIST on page 17.

HOW TO ADJUST THE BELT

If you can feel the pedals slip while you are pedaling,

even when the resistance of the pedals is at the high-

est setting, the Belt (37) may need to be adjusted.

First, remove all of the screws from both side shields;

there are three sizes of screws in the side

shields—note which size of screw you remove

from each hole.

Next, loosen the M8 x 19mm Flat Head Bolt (61) and

turn the Adjustment Screw (62) until the Belt (37) is

tight. Once the Belt is tight, tighten the Flat Head Bolt.

Then, reattach the side shields. Note: If you have

questions regarding which screw should be in which

hole, see EXPLODED DRAWING B on page 19 and

the PART LIST on page 17.

MAINTENANCE AND TROUBLESHOOTING

48

53

60

47

61

37

62