Healthrider H 300 HREL3226.0 User's Manual
Download Operation & user’s manual of Healthrider H 300 HREL3226.0 Home Gym, Other for Free or View it Online on All-Guides.com.
Brand: Healthrider
Type: Operation & user’s manual
Model: Healthrider H 300 HREL3226.0 , Healthrider H300 Elliptacal , Healthrider H300 W/mat Elliptical
Pages: 20 (1.25 Mb)
Download Healthrider H 300 HREL3226.0 Operation & user’s manual
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
8
8
9
10
2
18
60
60
17
66
9. While another person holds the Console (10) near
the Upright (2), connect the Upper Wire Harness
(18) to the wire harness on the Console.
Attach the Console (10) to the Upright (2) with four
M4 x 16mm Screws (60). Be careful not to pinch
the wire harnesses.
Attach the Water Bottle Holder (17) to the Upright
(2) with two M4 x 22mm Screws (66).
8. The Console (10) requires four “D” batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the elliptical exerciser has been
exposed to cold temperatures, allow it to warm
to room temperature before inserting batteries
into the Console. If you do not do this, the con-
sole displays or other electronic components
may become damaged. Remove the battery cover
from the Console. Insert four batteries into the
Console; make sure that the batteries are orient-
ed as shown by the diagram inside the battery
compartment. Then, reattach the battery cover.
10
Batteries
Battery
Cover
65
21
64
6
23
73
7. Attach the Left Pedal Arm (21) to the left Upper
Body Arm (6) with an M8 x 23mm Button Screw
(65), an M8 Washer (64), and a Pedal Leg Cover
(23).
Apply grease to a Large Wave Washer (20) and
slide it onto the Left Crank Arm (42). Then, attach
the Left Pedal Arm (21) to the Left Crank Arm with
an M8 x 25mm Patch Screw (70) and an M8 Large
Washer (81).
Repeat this step for the other side of the elliptical
exerciser.
See step 3. Tighten the four M8 x 19mm Patch
Screws (73).
7
20
81
70