HealthRider H10t Treadmill Manual
Download Manual of Healthrider H10t Treadmill Other, Treadmill for Free or View it Online on All-Guides.com.
1
2
3
4
5
6
7
8
9
10
11
12
5
1
27
Tab
6. The Console (1) requires two “AAA” batteries (not includ-
ed). Alkaline batteries are recommended. Press the indi-
cated tab on the Battery Cover (27) and remove the
Battery Cover. Insert two batteries into the two battery
clips; make sure that the negative (–) ends of the bat-
teries are touching the springs in the battery clips.
9. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or carpet,
place a mat under the treadmill. Note: If a part is not in the hardware kit, check to see if it is preattached to
one of the parts to be assembled. Extra hardware may be included.
34
33
35
36
2
5
6
34
33
5. Hold the Handrail (5) near the Left and Right Uprights (35,
36). Connect the Handrail Wire (2) to the Reed Switch
Wire (6). Insert the Wires down into the Left Upright.
Attach the Handrail (5) to the Uprights (35, 36) with four
M
8 x 15mm Bolts (33) and four M8 Washers (34). Be
careful not to pinch the Wires (2, 6).
5
Batteries
6
7. See drawing 7a. Hold the Console (1) near the Handrail
(5). Connect the wire on the Console to the Handrail
Wire (2). Attach the Console to the Handrail with two M4
x 12mm Screws (3). Be careful not to pinch the wires.
See drawing 7b. Press the Battery Cover (27) back onto
the Console (1).
29
20
30
8. Remove the paper backing from the Adhesive Clip (30).
Press the Adhesive Clip onto the left side of the Frame
(29) in the indicated location. Press the Hex Key (20) into
the Adhesive Clip.
Make sure that the walking belt is properly tightened (see
SYMPTOM 2 and SYMPTOM 3 on page 8).
8
27
3
5
1
2
7a
7b
1