Heath Zenith SL-9525 User Manual

Download Operation & user’s manual of Heath Zenith SL-9525 Security System for Free or View it Online on All-Guides.com.

Brand: Heath Zenith

Category: Security System

Type: Operation & user’s manual for Heath Zenith SL-9525

Pages: 12 (0.81 Mb)

Download Heath Zenith SL-9525 Operation & user’s manual

Heath Zenith SL-9525 Operation & user’s manual - Page 1
1
Heath Zenith SL-9525 Operation & user’s manual - Page 2
2
Heath Zenith SL-9525 Operation & user’s manual - Page 3
3
Heath Zenith SL-9525 Operation & user’s manual - Page 4
4
Heath Zenith SL-9525 Operation & user’s manual - Page 5
5
Heath Zenith SL-9525 Operation & user’s manual - Page 6
6
Heath Zenith SL-9525 Operation & user’s manual - Page 7
7
Heath Zenith SL-9525 Operation & user’s manual - Page 8
8
Heath Zenith SL-9525 Operation & user’s manual - Page 9
9
Heath Zenith SL-9525 Operation & user’s manual - Page 10
10
Heath Zenith SL-9525 Operation & user’s manual - Page 11
11
Heath Zenith SL-9525 Operation & user’s manual - Page 12
12
© 2003 DESA Specialty Products™ 595-5612-08
Mode: On-Time: Works: Day Night
Test 5 Sec x x
Auto 1, 5, 10 min. x
Manual Until Dawn* x
OPERATION
* resets to Auto Mode at dawn.
MANUAL MODE
ON-TIME
10 5 1 TEST
10 5 1 TEST
ON-TIME
TEST
... back on.
AUTO
1 Second OFF
then...
Move ON-TIME Switch to
1, 5, or 10 minutes
Mode Switching Summary
Flip light switch off
for one second then
back on*
MANUAL MODE
AUTO
TEST
Requirements
The Light Control requires 120-volts AC.
If you want to use Manual Mode, the control must be
wired through a switch.
Some codes require installation by a
qualified electrician.
This product is intended for use with the enclosed
gasket and with a junction box marked for use in wet
locations.
Model SL-9525
Features
Turns on lighting when motion is detected.
Automatically turns lighting off.
Photocell keeps the lighting off during daylight hours.
LED indicates motion was sensed (day or night).
Motion Sensor Light
Control
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the
calibration time the control will be in the AUTO mode.
Note: When first turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
Gasket
4 Screws
(2 sizes included)
2 Flood Lamps
2 Wire
Connectors
This package includes:
Light Control
Sensor
Cover
Plate
Lamp Holders
2 Shells
Light Shield
As an ENERGY STAR
®
Partner, Heath
®
/Ze-
nith has determined that this product meets
the ENERGY STAR
®
guidelines for energy
efficiency. This product is ENERGY STAR
®
compliant when used with 120 Watt bulbs.
Manual mode only works at night
because daylight returns the sen-
sor to AUTO.
Flip the light switch off for one sec-
ond then back on to toggle between
AUTO and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 10
position.
Put the ON-TIME switch in the 1, 5,
or 10 minute position.
Put the ON-TIME switch on the
bottom of the sensor in the TEST
position.