• Home
• Brands
• HP Manuals
• HP StorageWorks 2000sa - G2 Modular Smart Array
• Hewlett-Packard StorageWorks 2000fc - G2 Modular Smart Array Installation Instructions

Hewlett-Packard StorageWorks 2000fc - G2 Modular Smart Array Installation Instructions

Download Installation instructions of HP StorageWorks 2000sa - G2 Modular Smart Array Adapter, Enclosure for Free or View it Online on All-Guides.com.

1

2

3

HP StorageWorks

Carrier-Grade Enclosure

installation instructions

This document provides specific information regarding

the carrier-grade versions of the HP StorageWorks

Dual I/O 2.5" DC-power Drive Enclosure.

© Copyright 1999, 2009 Hewlett-Packard Development Company,

L.P.

First edition: October 2009

The information in this document is subject to change without notice.

Printed in the US

www.hp.com

*589728-001*

Cable information

This section provides cabling information for installing the HP

StorageWorks Dual I/O 2.5" DC-power Drive Enclosure.

NOTE:

This carrier-grade product is intended for use in both common

bonding networks and isolated bonding networks.

NEBS chassis ground

There are two grounding methods that can be used when installing the

HP StorageWorks Dual I/O 2.5" DC-power Drive Enclosure:

• Using a single wire coming from the front of the chassis ears

• Using a cable from the power supply

Installation and grounding instructions — single wire method

1. Attach the rear brackets to the Carrier-Grade Enclosure.

2. Attach the left bracket assembly to the left rack rail.

3. Attach the right bracket assembly to the right rack rail.

4. Insert cage nuts into the rack holes.

5. Align the Carrier-Grade Enclosure with the rails, and then slide it

into the rack until the ears of the enclosure are about 1 to 2 inches

from the rack front rails.

6. Attach a flat washer between the right mounting ear (bottom hole)

and the rack, and then loosely attach the bracket to the rear bracket

assemblies.

Page 1