Hewlett-Packard AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Installation Manual
Download Installation manual of HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive Carrying Case, Network Hardware for Free or View it Online on All-Guides.com.
Brand: HP
Category: Carrying Case , Network Hardware , Speaker System , Storage , Switch
Type: Installation manual
Model: HP AD510A - StorageWorks Modular Smart Array 1500 cs 2U Fibre Channel SAN Attach Controller Shelf Hard Drive , HP AE326A - StorageWorks Modular Smart Array 1500 SAN SATA Starter , HP StorageWorks 1500cs - Modular Smart Array
Pages: 126 (7.67 Mb)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
Configuration Procedures - HP-UX Environments
84 HP StorageWorks 1500 Modular Smart Array Installation Guide
Installing the ACU-CLI on the servers (optional)
To use the ACU-CLI to configure MSA storage, perform the following steps to
install it on the servers:
Note:
■ You must remove earlier versions of the ACU before installing later versions.
■ For information about using the ACU-CLI, see ACU-CLI online help, the HP-UX
ACU-CLI readme file or release notes, or the HP Configuring Arrays Reference
Guide.
1. Insert the Support Software CD in the CD-ROM drive of the server.
Note: If you created a new Support Software CD from the Web, insert that CD in the
CD-ROM drive of the server and do not use the shipping version of the CD. For more
information, see:
■ “Determine which version MSA controller firmware to use” on page 17
■ “Obtain desired controller firmware and Support Software CD versions” on page 61
2. From the console, mount the CD-ROM drive and navigate to the
/HPUXACUCLI/HP-UX directory for your environment.
3. List the contents of the directory and identify the ACU-CLI depot file for your
environment.
4. Copy the ACU-CLI depot file and its corresponding readme file to a
temporary directory on the server. For example:
# cp /HPACUCLI/HP-UX/IA64/HPACUCLI_IA_v7.47-1.depot .tmp
5. Install the ACU-CLI application using the swinstall command. For example:
# swinstall -s /tmp/HPACUCLI_IA_v7.47-1.depot
6. Remove the Support Software CD from the CD-ROM drive.
Note: To start the ACU-CLI, do the following from the console: Navigate to the
/opt/compaq/hpacucli/bld directory, and then enter # ./hpacucli
.