Hewlett-Packard 7500 Series Installation Manual
Download Installation manual of HP Photosmart 7500 Firewall, Printer for Free or View it Online on All-Guides.com.
Brand: HP
Category: Firewall , Printer , Switch
Type: Installation manual for HP Photosmart 7500
Pages: 151 (9.19 Mb)
27
Figure 23 Panel view of the 2800W AC
(1) Captive screws
(2) System power
receptacle
(3) Power switch (O for off, and — for on) (4) Status LEDs
(5) PoE power receptacle (6) PoE power
switch (O for off, and — for on)
(7) Hole for fixin
g
a cable tie (8) Power supply handle
The power cord connection procedures are the same for the system power receptacle and PoE power
receptacle of the 2800W AC power supply. This section takes the system power receptacle for example.
To connect the AC power cord to the system power receptacle of the power supply:
1. Make sure of the power cord model (the 2800W AC uses a 16 A AC power cord).
2. Plug the power cord to the system power receptacle on the power supply, and ensure a good
contact.
3. Secure the power cord to the power supply handle by using a cable tie, as shown in Figure 24.
4. Plug the oth
er end of the power cord to the AC power receptacle of the power source.
5. Turn on the power switch.
6. Examine the power supply input status LED.
If the LED is green, the power cord is correctly connected. If the LED is off or red, examine the
installation, and solve the problem. Then switch on the power supply to verify that the LED is green.
For description of 2800W AC status LEDs, see "Appendix C LEDs."