Hewlett-Packard A-F5000 Installation Manual
Download Installation manual of HP A-F5000 Firewall for Free or View it Online on All-Guides.com.
61
To do… Use the command… Remarks
Enter AUX user interface view user-interface aux 0 —
Specify the none authentication mode authentication-mode none Required
Configure the user privilege level user privilege level 3 Required
NOTE:
• To use the default authentication mode (password authentication) for AUX port lo
g
in, you must confi
g
ure
the user level and password.
• The AUX port can work in the flow mode (default) or protocol mode. The AUX port can be used as the
backup console port only when it works in the flow mode.
• Use the async mode { flow | protocol } command to switch between the flow mode and the protocol
mode. For more information, see the command references for the firewall.
Password loss
User password loss
If you lose your password, you cannot enter the system. In this case, you can boot the system by ignoring
the system configuration.
Follow these steps to solve the user password loss:
1. Enter the main BootWare menu, and select 6 to boot the system by ignoring the system
configuration.
The system prompts the following:
Flag Set Success.
The output indicates that the setting succeeded.
2. When the main BootWare menu appears again, and select 0 to reboot the system.
System start booting...
Booting Normal Extend BootWare....
3. Set a new password in system view after the system reboots.
<Sysname> system-view
[Sysname] user-interface console 0
[Sysname-ui-console0] authentication-mode password
[Sysname-ui-console0] set authentication password simple 123456
The output shows that the console port uses password authentication, and the password is set to 123456
and stored in plain text.
NOTE:
• After reboot, the system runs with the initial default configuration, but the original configuration file is still
stored in the storage medium. To restore the original configuration, use the display saved-confi
g
uration
command to display the configuration, and then copy and execute the configuration.
• If the password is stored in plain text, you can use the display current-configuration command to vie
w
the password in the current configuration. If the password 12 3456 is set with the set authentication
password cipher command, the password is stored in cipher text.