Hewlett-Packard Mediant 2000 User's Manual
Download Operation & user’s manual of HP Mediant 2000 Gateway for Free or View it Online on All-Guides.com.
Brand: HP
Category: Gateway
Type: Operation & user’s manual for HP Mediant 2000
Pages: 496 (6.06 Mb)
Version 5.8 113 October 2009
SIP User's Manual 3. Web-Based Management
Parameter Description
In addition, for a SIP call that is identified by both the Served
Trunk Group/ Served IP Group
For Tel-to-IP calls, the Serving IP Group is the destination IP
Group defined in the '
and Serving IP Group, the
username and password for digest authentication defined in this
table is used.
Trunk Group Settings' table or 'Tel to IP
Routing' table (refer to ''Configuring the Tel to IP Routing Table''
138
on page ). For IP-to-Tel calls, the Serving IP Group is the
'Source IP Group ID' defined in the 'IP to Trunk Group Routing'
table (refer to ''Configuring the IP to Trunk Group Routing''
145
on
page ).
Note:
Username
If no match is found in this table for incoming or outgoing
calls, the username and passwordthe global parameters
(UserName and Password) defined on the 'Proxy & Registration'
page.
Digest MD5 Authentication user name (up to 50 characters).
[Account_Username]
Password Digest MD5 Authentication password (up to 50 characters).
[Account_Password]
Host Name Defines the Address of Record (AOR) host name. It appears in
REGISTER From/To headers as ContactUser@HostName. For
successful registrations, this HostName is also included in the
INVITE request's From header URI. If not configured or if
registration fails, the 'SIP Group Name' parameter from the ‘IP
Group’ table is used instead.
[Account_HostName]
This parameter can be up to 49 characters.
Register Enables registration.
[Account_Register]
[0]
No = Don't register
[1]
When enabled, the device sends REGISTER requests to the
Serving IP Group. In addition, to activate registration, you also
need to set the parameter 'Registration Mode' to 'Per Account' in
the '
Yes = Enables registration
Trunk Group Settings' table for the specific Trunk
REGISTER sip:audiocodes SIP/2.0
Via: SIP/2.0/UDP
10.33.37.78;branch=z9hG4bKac1397582418
From:
<sip:ContactUser@HostName>;tag=1c1397576231
To: <sip: ContactUser@HostName >
Call-ID: [email protected]
CSeq: 1 REGISTER
Contact:
<sip:[email protected]>;expires=3600
Expires: 3600
User-Agent: Audiocodes-Sip-
Gateway/v.5.80A.008.002
Content-Length: 0
Group. The
Host Name (i.e., host name in SIP From/To headers) and Contact
User (user in From/To and Contact headers) are taken from this
table upon a successful registration. See the example below: