Hewlett-Packard Mediant 2000 User's Manual
Download Operation & user’s manual of HP Mediant 2000 Gateway for Free or View it Online on All-Guides.com.
Brand: HP
Category: Gateway
Type: Operation & user’s manual for HP Mediant 2000
Pages: 496 (6.06 Mb)
SIP User's Manual 130 Document #: LTRT-68809
Mediant 2000
prefixes.
The number manipulation is configured in the following tables:
Assigning Numbering Plan Indicator (NPI)/Type of Numbering (TON) to IP-to-Tel calls.
The device can use a single global setting for NPI/TON classification or it can use the
setting in the manipulation tables on a call-by-call basis.
• Destination Phone Number Manipulation Table for Tel-to-IP Calls
(NumberMapTel2IP
For Tel-to-IP calls:
ini
• Source Phone Number Manipulation Table for Tel-to-IP Calls
(SourceNumberMapTel2IP
file parameter) - up to 100 entries
ini file parameter) - up to 120
entries
• Destination Phone Number Manipulation Table for IP-to-Tel Calls
(NumberMapIP2Tel
For IP-to-Tel calls:
ini
• Source Phone Number Manipulation Table for IP-to-Tel Calls
(SourceNumberMapIP2Tel
file parameter) - up to 100 entries
ini
The device matches manipulation rules starting at the top of the table. In other words, a rule
at the top of the table takes precedence over a rule defined lower down in the table.
Therefore, define more specific rules above more generic rules. For example, if you enter
551 in Index 1 and 55 in Index 2, the device applies rule 1 to numbers that start with 551
and applies rule 2 to numbers that start with 550, 552, 553, and so on untill 559. However,
if you enter 55 in Index 1 and 551 in Index 2, the device applies rule 1 to all numbers that
start with 55, including numbers that start with 551.
file parameter) - up to 20 entries
Notes:
• Number manipulation can occur before or after a routing decision is
made. For example, you can route a call to a specific Trunk Group
according to its original number, and then you can remove or add a prefix
to that number before it is routed. To determine when number
manipulation is performed, configure the 'IP to Tel Routing Mode'
parameter (RouteModeIP2Tel) described in ''Configuring the IP to Trunk
Group Routing'' 145 on page , and 'Tel to IP Routing Mode' parameter
(RouteModeTel2IP) described in ''Configuring the Tel to IP Routing
Table'' on page 138 (or Configuring the Outbound IP Routing Table on
page 142)
• The manipulation rules are executed in the following order:
1. Stripped digits from left.
2. Stripped digits from right.
3. Number of digits to leave.
4. Prefix to add.
5. Suffix to add.
.
• The manipulation rules can be applied to any incoming call whose source
IP address (if applicable), source Trunk Group (if applicable), source IP
Group (if applicable), destination number prefix and source number prefix
matches the values defined in the 'Source IP Address', 'Source Trunk
Group', 'Source IP Group', 'Destination Prefix', and 'Source Prefix' fields
respectively. The number manipulation can be performed using a
combination of each of the above criteria, or using each criterion
independently.
• For available notations representing multiple numbers/digits for
destination and source prefixes, refer to ''Dialing Plan Notation for
Routing and Manipulation'' 399 on page .
• For configuring number manipulation using ini file table parameters
NumberMapIP2Tel, NumberMapTel2IP, SourceNumberMapIP2Tel, and
SourceNumberMapTel2IP, refer to ''Number Manipulation and Routing
Parameters'' 348 on page .