Hewlett-Packard Mediant 2000 User's Manual
Download Operation & user’s manual of HP Mediant 2000 Gateway for Free or View it Online on All-Guides.com.
Brand: HP
Category: Gateway
Type: Operation & user’s manual for HP Mediant 2000
Pages: 496 (6.06 Mb)
SIP User's Manual 218 Document #: LTRT-68809
Mediant 2000
Possible values for AuthProtocol:
• 0 – none
• 1 - MD5
• 2 - SHA-1
Possible values for PrivProtocol:
• 0 – none
• 1 – DES
• 3 - AES128
5. To end the PuTTY configuration session, type a full-stop (“.”) on an empty line; the
device responds with the following:
INI File replaced
6. To save the configuration to the non-volatile memory, type sar
; the device reboots with
IPSec enabled.
5.9.2 Configuring EMS to Operate with a Pre-configured SNMPv3
System
The procedure below describes how to configure the device with a pre-configured SNMPv3.
To configure the EMS to operate with a pre-configured SNMPv3 system:
1. In the MG Tree, select the required Region to which the device belongs, and then
right-click the device.
2. From the shortcut menu, choose Details
Figure 5-11: MG Information Screen
; the 'MG Information' screen appears.
3. Select the SNMPv3 option, configure the SNMP fields, and then click OK
4. Open the 'SNMPv3 Users' screen (
.
Network tab > SNMPv3 Users
5. Select the tabs arrow button, and then from the shortcut menu, choose
tab).
Unit Value
6. Click the
; the
'SNMPv3 Users' table is refreshed with the values that you entered in Step 3.
Save
button; the EMS and the device are now synchronized.