Hewlett-Packard Mediant 2000 User's Manual
Download Operation & user’s manual of HP Mediant 2000 Gateway for Free or View it Online on All-Guides.com.
Brand: HP
Category: Gateway
Type: Operation & user’s manual for HP Mediant 2000
Pages: 496 (6.06 Mb)
SIP User's Manual 224 Document #: LTRT-68809
Mediant 2000
Parameter Description
For this parameter to take effect, a device reset is required.
Note:
Enable LAN Watchdog is relevant only if the Ethernet connection
is full duplex.
6.1.2 Multiple IP Interfaces and VLANs Parameters
The IP network interfaces and VLAN parameters are described in the table below.
Table 6-2: IP Network Interfaces and VLAN Parameters
Parameter Description
Web: Multiple Interface Table
EMS: IP Interface Settings
Multiple Interface Table
This
[InterfaceTable]
ini file table parameter configures the Multiple Interface
table for configuring logical IP addresses. The format of this
parameter is as follows:
[InterfaceTable]
FORMAT InterfaceTable_Index =
InterfaceTable_ApplicationTypes,
InterfaceTable_InterfaceMode, InterfaceTable_IPAddress,
InterfaceTable_PrefixLength, InterfaceTable_Gateway,
InterfaceTable_VlanID, InterfaceTable_InterfaceName
For example:
;
[\InterfaceTable]
InterfaceTable 0 = 0, 0, 192.168.85.14, 16, 0.0.0.0, 1,
Management;
InterfaceTable 1 = 2, 0, 200.200.85.14, 24, 0.0.0.0, 200,
Control;
InterfaceTable 2 = 1, 0, 211.211.85.14, 24, 211.211.85.1, 211,
Media;
The above example, configures three network interfaces
(OAMP, Control, and Media).
Notes:
For this
Up to 16 logical IP addresses with associated VLANs can
be defined (indices 0-15). However, only up to 8 interfaces
can be used for media RTP traffic (assigned to a Media
Realm in the 'SIP Media Realm' table, which in turn is
assigned to an IP Group).
ini
file table parameter to take effect, a device reset
is required.
Each interface index must be unique.
Each IP interface must have a unique subnet.
Subnets in different interfaces must not be overlapping in
any way (e.g., defining two interfaces with 10.0.0.1/8 and
10.50.10.1/24 is invalid). Each interface must have its own
address space.
Upon device start up, this table is parsed and passes
comprehensive validation tests. If any errors occur during
this validation phase, the device sends an error message to
the Syslog server and falls back to a “safe mode”, using a