Hewlett-Packard Mediant 2000 User's Manual
Download Operation & user’s manual of HP Mediant 2000 Gateway for Free or View it Online on All-Guides.com.
Brand: HP
Category: Gateway
Type: Operation & user’s manual for HP Mediant 2000
Pages: 496 (6.06 Mb)
Version 5.8 235 October 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
(soft reset via Web interface doesn't trigger the BootP/DHCP
procedure and this parameter reverts to 'Disable').
Throughout the DHCP procedure the BootP/TFTP application
must be deactivated, otherwise, the device receives a response
from the BootP server instead of from the DHCP server.
For additional information on DHCP, refer to the Product
Reference Manual
This parameter is a special 'Hidden' parameter. Once defined
and saved in flash memory, its assigned value doesn't revert to
its default even if the parameter doesn't appear in the
.
ini
EMS: DHCP Speed Factor
file.
Determines the DHCP renewal speed.
[DHCPSpeedFactor]
[0]
= Disable
[1]
= Normal (default)
[2] to [10]
When set to 0, the DHCP lease renewal is disabled. Otherwise, the
renewal time is divided by this factor. Some DHCP-enabled routers
perform better when set to 4.
= Fast
Note:
For this parameter to take effect, a device reset is required.
Enables or disables DHCP renewal support.
[EnableDHCPLeaseRenewal]
[0]
= Disable (default)
[1]
This parameter is applicable only if DHCPEnable is set to 0 for
cases where booting up the device using DHCP is not desirable, but
renewing DHCP leasing is. When the device is powered up, it
attempts to communicate with a BootP server. If there is no
response and if DHCP is disabled, the device boots from flash. It
then attempts to communicate with the DHCP server to renew the
lease.
= Enable
Note:
For this parameter to take effect, a device reset is required.