Hewlett-Packard Mediant 2000 User's Manual
Download Operation & user’s manual of HP Mediant 2000 Gateway for Free or View it Online on All-Guides.com.
Brand: HP
Category: Gateway
Type: Operation & user’s manual for HP Mediant 2000
Pages: 496 (6.06 Mb)
Version 5.8 313 October 2009
SIP User's Manual 6. Configuration Parameters Reference
Parameter Description
[ProtocolType_x]
Same as the description for parameter ProtocolType, but for a
specific trunk ID (where x denotes the Trunk ID and 0 is the first
trunk).
Web/EMS: Trace Level
[TraceLevel]
Defines the trace level:
[0] No Trace (default)
[1] Full ISDN Trace
[2] Layer 3 ISDN Trace
[3] Only ISDN Q.931 Messages Trace
[4] Layer 3 ISDN No Duplication Trace
Web/EMS: Framing Method
[FramingMethod]
Determines the physical framing method for the trunk.
[0] Extended Super Frame = (Default) Depends on protocol
type:
E1: E1 CRC4 MultiFrame Format extended G.706B (same
as c)
T1: T1 Extended Super Frame with CRC6 (same as D)
[1] Super Frame = T1 SuperFrame Format (as B).
[a] E1 FRAMING DDF = E1 DoubleFrame Format - CRC4 is
forced to off
[b] E1 FRAMING MFF CRC4 = E1 CRC4 MultiFrame Format -
CRC4 is always on
[c] E1 FRAMING MFF CRC4 EXT = E1 CRC4 MultiFrame
Format extended G.706B - auto negotiation is on. If the
negotiation fails, it changes automatically to CRC4 off (ddf)
[A] T1 FRAMING F4 = T1 4-Frame multiframe.
[B] T1 FRAMING F12 = T1 12-Frame multiframe (D4).
[C] T1 FRAMING ESF = T1 Extended SuperFrame without
CRC6
[D] T1 FRAMING ESF CRC6 = T1 Extended SuperFrame with
CRC6
[E] T1 FRAMING F72 = T1 72-Frame multiframe (SLC96)
[F] T1 FRAMING ESF CRC6 J2 = J1 Extended SuperFrame
with CRC6 (Japan)
[FramingMethod_x]
Same as the description for parameter FramingMethod, but for a
specific trunk ID (where x denotes the Trunk ID and 0 is the first
Trunk).
Web/EMS: Clock Master
[ClockMaster]
Determines the Tx clock source of the E1/T1 line.
[0] Recovered = Generate the clock according to the Rx of the
E1/T1 line (default).
[1] Generated = Generate the clock according to the internal
TDM bus.
Notes:
The source of the internal TDM bus clock is determined by the
parameter TDMBusClockSource.
For detailed information on configuring the device's clock
settings, refer to Clock Settings on page 471.