Hewlett-Packard A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual
Download Hardware manual of HP rp2400 Desktop, Motherboard for Free or View it Online on All-Guides.com.
Brand: HP
Category: Desktop , Motherboard , Server
Type: Hardware manual
Model: HP rp2400 , HP A4500A - VMEbus Single Board Computer 744 Motherboard
Pages: 202 (8.16 Mb)
Chapter
Configuring the Guardian Service Processor (GSP)
115
Removing Users
You can remove (disable) a GSP user with the same Security options and access control (SO) command used to
add a user.
To remove a user, perform the following steps:
Step 1. Enter
ctrl + b to access the GSP.
Step 2. At the GSP prompt, enter the Security options and access control (SO) command:
GSP> so
Step 3. The first prompt you will see with the so command is for the following GSP-wide parameters:
• Login Timeout: 1 minute.
• Number of password Faults allowed: 3.
• Flow Control Timeout: 5 minutes.
The terminal will then display:
Do you want to modify the GSP wide parameters? (Y / [N]) __
Enter N and continue to the next step.
NOTE You may need to step through several user numbers until you reach the user to be
removed.
Step 4. When you access the number of the user to be removed, modify the User’s state to Disabled and
change any other user information necessary.
Changing the Default GSP Configuration
This section describes the process of changing GSP default configuration to the default (factory preset) values.
To reset the GSP to its default configuration, perform the following steps:
Step 1. Enter
ctrl + b to access the GSP.
Step 2. At the GSP prompt, enter the Default Configuration (dc) command:
GSP>co
Step 3. Follow the prompts to change all GSP configurations to the default values.
CAUTION When the Security configuration is reset using the GSP>dc command, all users, including the
GSP administrator, are removed Remote is disabled, and the network configurations are reset
to the factory default values. The Remote functionality must be re-enabled through the main
console using the Enable Remote (er) command. The IP address, hostname, subnetmask, and
the gateway IP must be re-entered through the main console using the LAN Configuration (lc)
command.