Hewlett-Packard A4500A - VMEbus Single Board Computer 744 Motherboard Hardware Manual
Download Hardware manual of HP rp2400 Desktop, Motherboard for Free or View it Online on All-Guides.com.
Brand: HP
Category: Desktop , Motherboard , Server
Type: Hardware manual
Model: HP rp2400 , HP A4500A - VMEbus Single Board Computer 744 Motherboard
Pages: 202 (8.16 Mb)
Chapter
System Console Configuration
139
System Console Configuration
The following describes the steps required to configure the HP C1099A or 700/96 terminal for VT-100 mode
for operation with an rp24xx server.
C1099A VT-100 Mode Configuration.
The following procedure outlines the steps to configure the C1099A terminal for VT-100 operation.
To access the Setup menu in HPTerm emulation:
1. Press the
F10 key to display the terminal local function labels, then Press F8 (config keys).
You are now in the Quick (
F1) menu.
2. Select the VT100 emulation by using the space bar to navigate through the available options.
3. Press the
ESC key to save selected setup parameters and to exit the Setup menu.
4. Press the
Y key when the blinking prompt
Save all? (Y/N)
appears in the upper right corner of the menu to save the settings in non-volatile memory.
NOTE If you enter N when the
Save all? (Y/N)
prompt appears, the changes will take effect, but will be lost if the terminal is reset or
powered off.
HP700 VT-100 Mode Configuration
The following procedure outlines the steps to configure the HP700 series terminal for VT-100 operation.
NOTE You may use either the arrow keys or the tab key to move between the setting options on the
screen.
Be sure to save any configuration changes you make before proceeding to a new menu.
1. Press
[User System] key.
2. Press
[config keys] function key. [f8]
3. Press [terminal config] function key. [f5]
4. Move to Terminal ID and enter “vt100”.
5. Move to TermMode and, using the
[Prev] and [Next] keys, select “EM100”.
6. Save the configuration.
[f1]
7. Press the [config keys] function key. [f8]
8. Press the [ansi config] function key. [f6]