Hewlett-Packard rp7400 Manual
Download Manual of HP rp7400 Motherboard, Server for Free or View it Online on All-Guides.com.
1
Adding a Disk Drive
The internal disk drives (A upper and B lower) are located in the back of
the SPU. The internal disk drives are hot swapable when the proper
software and hardware procedures are followed.
To add a disk drive in the SPU, perform the following hardware steps:
1. Align the new disk drive into the disk tray and insert the four (2 on
each side) mounting screws to secure the disk to the tray.
2. Align the disk and tray assembly to the empty slot in the back of the
SPU.
3. Carefully slide the disk into the SPU until it firmly seats into the disk
card. Note that the guide tabs on each side of the disk tray fully seat
to the guide pins on the chassis.
4. Angle the bottom of the disk cover plate into the SPU so that the
hooked tabs go over the extended pins inside the chassis. This acts
like a hinge for the cover.
5. Push the top of the cover plate towards the SPU until it is flush with
the chassis and fully seated.
6. Tighten the single, captive mounting screw.