Hewlett-Packard J3278B - SureStore CD-ROM Server/Tower 7 NAS Server Quick Setup

Download Quick setup manual of HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server Network Storage Server for Free or View it Online on All-Guides.com.

HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server Quick setup manual - Page 1
1
HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server Quick setup manual - Page 2
2
Configure IP settings
Verify hardware installation
HP
SureStore
Network Attached Storage
1
5
4
2
Locate parts
Quick Setup
Press to use
DHCP/BOOTP or...
Press to set
IP manually
R
IP Address
000.000.000.000
1
2
You also need:
• A twisted-pair network cable with RJ-45 connectors (not included).
• Two power outlets.
• An IP address, subnet mask, and, optionally, the default gateway
(router). Configure them using DHCP or BOOTP, or manually at the
server control panel. See your IP administrator for this information.
When the control panel prompts you (first two messages at left), do one of the following:
To set the IP settings using DHCP or BOOTP, press .
-or-
To set the IP settings manually at the control panel, follow these steps:
1. Press . The third message at left appears, with the first 0 blinking.
2. Enter the IP address. Use ▲▼to change the blinking number, and press to select a
number and move to the next space. (Use to move to a previous space.) Once you set
the last number, press
to accept the new IP address.
3. Enter the subnet mask. Press . To change the subnet mask, press and enter a new
one the same way you entered the IP address. When finished, press
.
4. Enter the default gateway . Press . To change the default gateway, press and enter
a new one the same way you entered the IP address. When finished, press
.
5. Press to exit setup mode, and then press to confirm.
Connect the network cable
On the back of the server, attach
the network cable between the
server and the network connector
at the wall.
Plug in power cords
3
1. Caution! Ensure that the
voltage switches are set
correctly for your country.
2. Plug the two power cords into
the back of the server, and
then plug the other ends of
the cords into the power
outlets.
Caution! 
If you need different power
cords than the ones supplied,
use power cords approved for
your country. See chapter 3 in
the User's Guide.
Locate the parts needed for installation:
HP SureStore 
HD Server 4000
Power Cords (2)
User's Guide (for 
more information)
On the front of the server, switch on the power and 
check the following:
If any of these checks fail, see chapter 11 in the User's Guide.
Main power light above power switch is 
on.
Control panel display shows varying 
self-test and loading messages. 
Power and activity lights for all hard
drives blink indicating self-test, and 
then power lights remain green.
Power display reads HP.