Hewlett-Packard Color LaserJet 1500 Service Manual
Download Service manual of HP 1500 All in One Printer, PDA for Free or View it Online on All-Guides.com.
Brand: HP
Category: All in One Printer , PDA , Printer
Type: Service manual for HP 1500
Pages: 312 (14.61 Mb)
ENWW 6 Troubleshooting 187
The Go (green) light is
blinking.
● The top cover has
been opened and
then closed
● You pressed
(ROTATE
CAROUSEL).
● Pressing (GO) returns the printer to the
Ready state. If you do not press (G
O), the
printer automatically returns to the Ready state
after approximately 10 seconds.
● Pressing (ROTATE CAROUSEL) brings
another print cartridge to the top position.
The Attention light is
blinking and the Go light
is on. The printer stops
printing.
A manual-feed job was
sent to the printer, and
the printer is waiting for
the special media.
1 Load media into tray 1.
2 If the printer does not begin printing after the
media has been reloaded, press (GO). Or,
press (GO) to try to print from another tray if
another tray is installed.
The printer has finished
printing the first side of a
manual-duplex job, and
the printer is waiting for
the pages to be reloaded
so it can print the second
side.
1 Reload the pages.
2 If the printer does not begin printing after the
pages have been reloaded, press (G
O).
Someone is trying to print
by Source (tray) and
there is no media in the
selected tray.
1 Add media to the selected tray to print from it.
2 Press (GO) to try to print from another tray.
The print image is larger
than the size of media in
the tray.
Load the correct-size media and press (GO).
The printer has an
Attention with Ability to
Continue error.
1 Press (G
O) for the printer to attempt to
recover from the error and print whatever data it
can. If successful, the printer completes the job
while the Ready light blinks.
2 If unsuccessful, the Attention with Ability to
Continue message continues to appear. Perform
one of these steps:
● Press and hold (GO) and
(C
ANCEL JOB) simultaneously to see a
secondary light pattern. (See “Attention with
Ability to Continue secondary messages” on
page 189.)
● Press (CANCEL JOB) to cancel the print
job. If the problem has been resolved, the
printer returns to the Ready state (Ready
light on)
The Attention light,
Ready light, and Go light
are blinking. The printer
stops printing, and
pressing any button has
no effect.
Accessory error. An
error has occurred with
either the EIO port or a
DIMM slot.
Press and hold (G
O) and (CANCEL JOB)
simultaneously to see a secondary light pattern.
(See “Accessory error secondary messages” on
page 191.)
Table 24. Printer Status light messages (continued)
Message Possible causes Solutions