Hewlett-Packard Color LaserJet 1500 Service Manual
Download Service manual of HP 1500 All in One Printer, PDA for Free or View it Online on All-Guides.com.
Brand: HP
Category: All in One Printer , PDA , Printer
Type: Service manual for HP 1500
Pages: 312 (14.61 Mb)
190 Troubleshooting Q2488-90901
Chosen Personality Not Available error
NOTE: This error can occur only with an HP color LaserJet 2500 series printer.
The Ready light and Go light are blinking. The current job was canceled because the printer language
(personality) is not supported or the carousel is not positioned correctly.
1 Ensure that the carousel is positioned correctly.
2 Press (GO) to clear the message.
3 If you printed the job using one of the PCL drivers, try printing using the PS driver, or vice versa.
4 Turn off the printer and remove or replace the language font DIMM
(HP color LaserJet 2500 series printers only).
CAUTION: You must turn off the printer before inserting or removing DIMMs.
Data Received error
NOTE: This error can occur only with an HP color LaserJet 2500 series printer.
The Go light is on.
The printer received data and is waiting for a form feed. Press (GO) to print the last page. Sending
another print job can also cause the page to print.
General Attention with Ability to Continue error
The Attention light, Ready light, and Go light are blinking.
1 Press (G
O) to try to continue printing.
2 If the error persists, switch printer drivers and try again to print.
68.x Permanent Storage error
The Attention light is blinking. The nonvolatile memory (NVRAM) is temporarily full.
1 Press (G
O) to clear the message. Check the printer settings.
2 Remove the Jetdirect card, if it is installed (HP color LaserJet 2500 series printers only), and then
perform a cold reset (see page 221).
3 Perform a NVRAM init (see page 221).
Table 25. Attention with Ability to Continue secondary messages (continued)