Hewlett-Packard P2015 - LaserJet B/W Laser Printer Service Manual
Download Service manual of HP LaserJet P2015 All in One Printer, Printer for Free or View it Online on All-Guides.com. This version of HP LaserJet P2015 Manual compatible with such list of devices, as: LaserJet P2015, LaserJet P2015d, LaserJet P2015dn, LaserJet P2015n, LaserJet P2015x
Brand: HP
Category: All in One Printer , Printer , Software
Type: Service manual
Model: HP LaserJet P2015 , HP LaserJet P2015d , HP LaserJet P2015dn , HP LaserJet P2015n , HP LaserJet P2015x
Pages: 296 (12.8 Mb)
Network reset
A network reset changes all network system parameters in NVRAM to the factory defaults. During
the network-reset process, all button presses are ignored.
Use the following procedure to perform a network reset.
1. Turn off the printer.
2. Press and hold the Job Cancel button.
3. Turn on the printer and continue to hold the Job Cancel button for approximately 10 seconds,
but no longer than 20 seconds. During this process, the Attention light turns on.
4. Release the Job Cancel button. The Attention, Ready, and Go lights begin cycling from front to
back. After the network-reset process is complete, the device returns to the ready state.
NOTE If the Attention and Ready lights illuminate before you release the Job Cancel
button, start again at step 1.
Cold reset
A cold reset changes most system parameters in NVRAM to the factory defaults. However, unlike
NVRAM initialization, a cold reset does not reset the page count, the paper tray sizes, language, or
formatter number.
NOTE A cold reset also resets all the HP Jetdirect settings as well as the printer settings.
Use the following procedure to perform a cold reset.
1. Turn off the printer.
2. Press and hold the Go button.
3. Turn the printer on, and continue to hold the Go button for at least 5 seconds, but not longer
than 15 seconds. During this process, the Attention LED turns on.
4. Release the Go button.
NOTE If both the Attention and the Ready LEDs turn on before you release the Go
button, you must start the procedure again with step 1.
The printer's LEDs begin cycling. The cold-reset process runs until completion, and the printer
returns to the ready state.
178 Chapter 7 Problem solving ENWW