Hewlett-Packard 6120G/XG Installation Instructions

Download Installation instructions of HP 6120XG Server for Free or View it Online on All-Guides.com.

Brand: HP

Category: Server

Type: Installation instructions

Model: HP 6120XG , HP ProCurve 6120G/XG

Pages: 4 (0.84 Mb)

Download HP 6120XG Installation instructions

HP 6120XG Installation instructions - Page 1
1
HP 6120XG Installation instructions - Page 2
2
HP 6120XG Installation instructions - Page 3
3
HP 6120XG Installation instructions - Page 4
4
HP ProCurve
6120XG Blade Switch
Installation Instructions
for HP c-Class BladeSystem
Overview
This card provides instructions for installing an HP ProCurve 6120XG
Blade Switch for c-Class BladeSystem in an HP c-Class BladeSystem
enclosure.
Kit contents
HP ProCurve 6120XG Blade Switch
Console cable (USB A to USB mini-AB)
Customer Support/Warranty booklet
License documentation
This document
IMPORTANT: Only use HP-approved pluggable SFP+ or SFP
optical transceiver modules or SFP+ direct attach cables. For
more information, see the QuickSpecs on the HP website
(http://www.hp.com/go/bladesystem/interconnects
).
HP ProCurve 6120XG Blade Switch
Additional information
For more information on the association between the server blade
mezzanine connectors and the interconnect bays, see the HP
BladeSystem enclosure setup and installation guide that ships with
the enclosure. During server blade installation, the location of the
mezzanine card determines the installation location of the switch
modules.
For specific switch port connection information for each blade, see
the HP BladeSystem enclosure setup and installation guide that ships
with the enclosure. Connections differ by blade type.
Installation guidelines
Observe the following guidelines:
All HP ProCurve switches in the enclosure require valid and
unique IP addresses before they can be accessed via Ethernet.
By default DHCP is enabled on these switches, so the switch
management interface can get IP credentials from the DHCP
server on the attached Ethernet network. If EBIPA is enabled on
the Onboard Administrator (OA) of the enclosure, OA will
assign an IP address to the switch from its configured IP
address range, so that switch can be accessed from the OA
Ethernet interface. If EBIPA is disabled but DHCP service is
available on the network attached to the OA Ethernet interface,
then the switch gets its IP address assigned from the attached
network. Any IP host on that network can access the switch at
this point. If the DHCP service is not available on the attached
network, the user can assign valid IP credentials from the
© Copyright 2009 Hewlett-Packard Development Company, L.P.
The information contained herein is subject to change without notice. The
only warranties for HP products and services are set forth in the express
warranty statements accompanying such products and services. Nothing
herein should be construed as constituting an additional warranty. HP shall
not be liable for technical or editorial errors or omissions contained herein.
Microsoft is a U.S. re
g
istered trademark of Microsoft Cor
p
oration.
Part Number 539957-001
September 2009 (First Edition)