Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
NOTE: The four connectors within the PCI card cage are identical and have the same capabilities.
You can install a compatible PCI card in any slot.
Installing the PCI Card Cage Assembly
To install the PCI card cage assembly, follow these steps:
WARNING! Ensure that the system is powered off and all power sources are disconnected
from the server prior to removing or installing server hardware.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION: Observe all ESD safety precautions while performing this procedure. Failure to
follow ESD safety precautions can result in damage to the server.
1. If the top cover is installed on the chassis, remove the top cover. See “Removing and Replacing
the Top Cover” (page 123).
2. If the PCI card cage cover is removed, insert the cover tabs (fan end of cover) into the
corresponding slots on the card cage and press the cover into position on the card cage. Slide
the cover toward the front of the card cage to secure the cover in place.
3. Orient the PCI card cage above the chassis as shown in Figure 7-15. Lift the release lever
and hold it in the open position. Lower the card cage into position and press gently to seat
the PCI card cage connectors.
Removing and Replacing the PCI Card Cage 133