Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
Table 1-6 Gigabit 10/100/1000 base-T Ethernet LAN A Status LEDs
StatusStateColorLocationLED
No 1000 Mbps link has been detected.
Port is linked at 1000 Mbps.
Off
On
GreenTop1. Gbit
No 100 Mbps link has been detected.
Port is linked at 100 Mbps.
Off
On
Green2nd from top2. 100 Mbit
No 10 Mbps link has been detected.
Port is linked at 10 Mbps.
Off
On
Green2nd from
bottom
3. Link
No LAN activity has been detected.
Flashing or lit solid indicates LAN activity.
Off
On
GreenBottom4. Activity
Management Processor LAN LEDs
The four management processor LAN LEDs display the status of the management LAN. The
LEDs are described in Table 1-7.
Table 1-7 Management LAN LEDs
StatusStateColorLocationLED
Self test is active.
Self test is active.
Off
On
YellowTopSelf Test
No Link detected or
100BT is active
Indicates 10BT LAN
activity.
Off
Flashing
Lit Steady
Green2nd from top10BT
10BT link established.
No Link detected or
10BT is active
Indicates 100BT LAN
activity.
Off
Flashing
Lit Steady
Green2nd from bottom100BT
100BT link
established.
Standby power is not
applied to
Off
On
GreenBottomStandby Power
management LAN
circuits.
Power is connected to
the server but the
server is not on.
System Board LEDs
There are three LEDs located on the system board that can be of assistance when troubleshooting.
These LEDs are located close to the rear of the server. View these LEDs through cooling holes
in the rear panel of the server. The LEDs are located as shown in Figure 1-7 and are described
in Table 1-8.
14 Controls, Ports, and Indicators