Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
CAUTION: Observe all ESD safety precautions while performing this procedure. Failure to
follow ESD safety precautions can result in damage to the server.
1. Clear a pathway of cables and set the fan control board in place, hooking its locking apertures
onto the standoff locks.
2. Slide the board toward the rear of the chassis (Figure 7-23 and Figure 7-24).
3. Install and tighten the single screw located at the top-left corner of the fan control board,
which secures the board to the standoffs on which it is mounted (Figure 7-24).
4. Install the terminating connectors on the cables (Figure 7-24).
5. Install the PCI-X airflow guide. See “Installing the PCI Airflow Guide” (page 128).
6. Install the DVD/optical drive. See “Installing the Optical Drive” (page 138).
Removing and Replacing the Management Processor Board
The management processor (MP) board is located on the rear of the system board under the top
cover. Since the LAN port on the MP board is configured with pertinent network settings, you
need to capture and snap-shot the settings information before you shut down your system. Refer
to Chapter 3, External Connectors, for details on how to configure the MP board using a Serial
Console Port connection.
WARNING! Ensure that the system is powered off and all power sources are disconnected
from the server prior to removing or installing server hardware.
Voltages are present at various locations within the server whenever a DC power source is
connected. This voltage is present even when the main power switch is turned off.
Failure to observe this warning can result in personal injury or damage to equipment.
CAUTION: Observe all ESD safety precautions while performing this procedure. Failure to
follow ESD safety precautions can result in damage to the server.
Figure 7-25 Management Processor Board
Removing and Replacing the Management Processor Board 145