Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
1. If rack-mounted, extend the server out from the rack until it stops. See “Installing Components
When the Server Is in a Rack” (page 114).
2. Power off the server. Disconnect all external cables.
3. Remove the server from the rack and place it on an ESD-protected work surface. See
“Removing the Server From a Rack” (page 115).
4. Remove the chassis top cover. See “Removing and Replacing the Top Cover” (page 123).
5. Remove all airflow guides. See “Removing and Replacing Airflow Guides” (page 127).
6. Remove the PCI-X card cage. See “Removing and Replacing the PCI Card Cage ” (page 131).
7. Loosen the five captive screws (T-15) that secure the center support member separating the
PCI-X cage compartment from the system board area to the chassis (Figure 7-47). Remove
the cable harness attached to the support member and remove the support member from
the server chassis.
Figure 7-47 Removing the Center Support Member
8. Remove the CPU processors. See “Removing and Replacing a System Processor” (page 147).
9. Remove the DIMM memory modules. See “Removing and Replacing System Memory
DIMMs” (page 128).
10. Remove the MP card. See “Removing the Management Processor Board” (page 146).
11. Label and disconnect all cables connected to the system board.
12. On the rear panel of the server chassis, remove the noncaptive screws and connector hardware
securing the following connectors:
• SCSI LVD (left) (hex 143-IN-LG 4-40 stainless steel)
• Serial A Console (right) (two screws - hex 2-56 w/slot stainless steel)
• Serial B (below Serial A console) (two screws - hex 2-56 w/slot stainless steel)
164 Removing and Replacing Components