Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
5. Remove the chassis top cover. See “Removing the Top Cover” (page 29).
CAUTION: Observe all ESD safety precautions while performing processor installation.
Failure to follow ESD safety precautions can result in damage to the server.
6. Remove the processor airflow guide by lifting it up and out of the server.
7. Ensure that the processor locking mechanism is rotated to the unlocked position (Figure 3-22).
Figure 3-22 Processor Locking Mechanism
8. Inspect the pins of the processor to be installed. Verify that the processor pins are not bent.
9. Insert the Allen side (hex) of the IPF-CPU install tool into the lock access hole that runs down
through the edge of the turbo fan heatsink before you place it on the system board. As you
place the turbo fan heatsink onto the system board, guide the tool until it connects. With
the IPF-CPU tool inserted into the lock access hole, it is easier to place and align the turbo
fan heatsink onto the system board.
10. Use the four locator posts on the heatsink and the turbo fan power cable to properly align
the fan and processor assembly on the system board (Figure 3-23). The four locator posts fit
in locator holes on the processor mount of the system board. Position the turbo fan power
cable so that it is located on the side of the heatsink that faces the front of the chassis.
Installing Processors 45