Hewlett-Packard Integrity cx2600 Maintenance Manual
Download Maintenance manual of HP Integrity cx2600 Server for Free or View it Online on All-Guides.com.
Drv[3F] Ctrl[19] Lang[eng]
Drv[45] Ctrl[1C] Lang[eng]
Drv[45] Ctrl[1D] Lang[eng]
This listing shows which driver controls which device (controller). This information describes
a SCSI interface because the values shown for Ctrl—17 and 18—are the controller’s handles
for the SCSI interface two channels (from the information displayed by the devtree
command).
NOTE: The EFI driver’s handle values change on every boot.
TIP: From this command (drvcfg), record these two pieces of information for each channel
of each SCSI interface for parameters to be changed:
• Drv (the EFI driver’s handle)
• Ctrl (the controller’s handle)
4. Using the driver’s handle [Drv] and the controller’s handle [Ctrl] from the drvcfg
command, start the EFI SCSI Setup Utility for one channel of this SCSI interface.
At the EFI Shell prompt, enter:
Shell> drvcfg -s drvr_handle cntrl_handle
where
• drvr_handle. The handle of the driver that controls the channel with the SCSI ID you
want to display or change
• cntrl_handle . The handle of the controller for the channel with the SCSI ID you
want to display or change
For channel A of this SCSI interface, enter:
Shell> drvcfg -s 45 18
5. The EFI SCSI Setup Utility starts and its main menu displays, showing a list of all the EFI
capable SCSI interfaces in the system.
Move the cursor to highlight the channel of the SCSI interface. Press Enter to determine
which channel of the interface to highlight, match the PCI-X Bus, PCI-X Dev, and
PCI-X Func values on this screen to the Bus #, Dev #, and Fnc # values from the
info io command.
CAUTION: Do not select the <Global Properties> option on the main menu.
TIP: To move the cursor in the EFI SCSI Setup Utility, use the following keys:
• Arrow keys: ↑ ↓ ← →
• Alternate keys:
H = left
J = down
K = up
L = right
I = home
O = end
6. The Adapter Properties screen for this channel of the SCSI interface displays. Be sure the
utility is running for the channel of the SCSI interface by comparing the values shown for
96 Utilities