Hewlett-Packard P4000 Maintenance Manual
Download Maintenance manual of HP StorageWorks P4000 Gateway, Network Storage Server for Free or View it Online on All-Guides.com.
Brand: HP
Category: Gateway , Network Storage Server , Server , Software , Storage
Type: Maintenance manual
Model: HP StorageWorks P4000 , HP StoreVirtual 4000
Pages: 53 (2.09 Mb)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
NOTE: If any items do not meet the requirements listed in Table 2 (page 17) and
Table 3 (page 17), do not continue with this procedure.
Table 2 Minimum requirements, overview category
Minimum requirementItem
CPU on the storage blade: Intel Xeon Processor @ 2.40
Ghz
CPU
37 hard drives, which include the following:
• Slot 2: 35 drives on the HP Smart Array P700m
controller
• Slot 0: 2 drives on the HP Smart Array P410i
controller
Type and number of drives
24 GBMemory
For the HP P4460sb G2 storage blade, the Network
Controller is Emulex OneConnect 10Gb NIC:
v3.102.453.0 or later.
NIC
9. From the Categories list, select Storage.
10. Verify that the specified item meets the minimum requirements listed in Table 3 (page 17).
Table 3 Minimum requirements, storage category
Minimum requirementItem
• Model: HP P410i
• Firmware: 3.52 or later
• Installed Memory: 0 Mbytes
• BIOS boot device order: 1
Array Controller in Slot 0: HP Smart Array P410i
controller
• Model: HP P700m
• Firmware: 7.22 or later
• Installed Memory: 512 Mbytes
• Battery1: OK
• BIOS boot device order: 2
Array Controller in Slot 2: HP Smart Array P700m
controller
Run server diagnostics
1. On the HP Insight Diagnostics Test tab, select Quick Test and specify the number of loops.
2. Press the Begin Testing button.
The Survey Tab displays the data from the tests.
Wait for the tests to finish. This may take several minutes.
3. When the tests have completed, select the Log tab and check the failure log to see if the Quick
Test reports any failures.
4. If the Quick Test reports any errors, fix all errors before continuing.
If you need more information about an error, run a Complete Test on any component that
reported a failure.
If you want to run only specific tests, use the Custom Test option.
For assistance with the Complete or Custom Test options, see the HP SmartStart CD x64 or
contact HP technical support.
5. Press the Exit Diagnostics button.
Performing field system recovery of the HP P4800 G2 solution 17