Hewlett-Packard StorageWorks 2/16 - SAN Switch Installation Manual
Download Installation manual of HP iPAQ 216 Cell Phone, Server for Free or View it Online on All-Guides.com.
Brand: HP
Category: Cell Phone , Server , Storage , Switch
Type: Installation manual for HP iPAQ 216
Pages: 100 (4.15 Mb)
Installing the SAN Switch 2/16
25SAN Switch 2/16 Version 3.1.2 Installation Guide
Installing the SAN Switch as a Stand-alone Unit
Use the following procedures to set up the switch as a stand-alone unit. The
following items are required for this setup:
■ SAN Switch 2/16
■ AC power cords and cables supplied with the switch
■ Rubber mounting feet supplied with the switch
1. Place the SAN Switch 2/16 or on a flat, sturdy surface like a table or lab
bench.
2. Apply the rubber feet as follows.
a. Clean the four depressions that are at each corner of the bottom of the
switch to ensure they are free of dust.
b. Place a rubber foot in each depression, with the adhesive side against the
chassis, and press into place.
Caution: HP recommends that you install the rubber feet on the switch to help
prevent the switch from accidentally sliding off the table or bench.
3. Connect the power cable to the SAN Switch 2/16 power supply and to a power
outlet. Ensure the power cable is routed so that it is not exposed to stress.
4. Turn on the power to the switch (flip the AC switch to 1). The switch
automatically runs a Power-On Self-Test (POST).
5. If the SAN Switch 2/16 includes a second power supply, repeat steps 3
through 4 for the second power supply.
Note: Do not connect the switch to the network until the IP address is correctly set. For
instructions on how to set the IP address, see “Configuring Network Addressing” on
page 39.