Hewlett-Packard StorageWorks 2/16 - SAN Switch Installation Manual
Download Installation manual of HP iPAQ 216 Cell Phone, Server for Free or View it Online on All-Guides.com.
Brand: HP
Category: Cell Phone , Server , Storage , Switch
Type: Installation manual for HP iPAQ 216
Pages: 100 (4.15 Mb)
Installing the SAN Switch 2/16
45SAN Switch 2/16 Version 3.1.2 Installation Guide
How to Change the Core PID Format
For the switches to interoperate properly, all of them must have the same Core
PID format. Execute the following procedure to change the Core PID format, if
necessary.
Caution: Remember that you must change the Core PID format before
connecting fiber cables.
1. If the switch is configured for zoning, issue the cfgDisable command to
disable zoning.
2. To disable the switch, issue the SwitchDisable command and press
Enter.
3. Issue the configure command and press Enter. The following
prompt displays:
Configure...
4. Enter y at the Fabric parameters prompt:
Fabric parameters (yes, y, no, n): [no] y
5. Locate the line, Core Switch PID Format: (0..1). Enter either 0
or 1 to match the SAN’s existing PID format.
6. Continue to press Enter until you have completed the configure section and
returned to the admin prompt.
7. Issue the SwitchEnable command and press Enter.
8. After setting the PID Format to match the other switches in the fabric, go to
the “Connecting the Switch to the LAN” section on page 43 for instructions
on connecting Fibre Channel cables.
9. If necessary, issue the cfgEnable command to reestablish zoning.
Note: After the switch PID format is set, it is stored in the flash memory of the switch; it
is not necessary to set it again during subsequent firmware upgrades.