Hewlett-Packard StorageWorks 2/16 - SAN Switch Installation Manual
Download Installation manual of HP iPAQ 216 Cell Phone, Server for Free or View it Online on All-Guides.com.
Brand: HP
Category: Cell Phone , Server , Storage , Switch
Type: Installation manual for HP iPAQ 216
Pages: 100 (4.15 Mb)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
Managing the SAN Switch 2/16
63SAN Switch 2/16 Version 3.1.2 Installation Guide
Configuring the IP and Fibre Channel Address
The SAN Switch 2/16 is shipped with a default IP address of 10.77.77.77.
Use these steps to change the default IP address and configure the Fibre Channel
IP address of the switch.
1. Log in to the switch as the admin user.
2. At the command line, issue the ipAddrSet command.
An interactive session opens and you are prompted for configuration values.
Press Enter to skip a prompt and leave the parameter value as is.
3. At the Ethernet IP Address prompt, enter the new IP address for the
Ethernet port on the switch. Press the Enter to continue.
4. At the Ethernet Subnetmask prompt, enter the address of the
subnetmask, if applicable. Press Enter to continue.
5. At the Fibre Channel IP address prompt, enter the Fibre Channel IP
address for the switch. Press Enter to continue.
6. At the Fibre Channel Subnetmask prompt, enter the address of the
subnetmask, if applicable. Press Enter to continue.
7. At the Gateway Address prompt, enter the IP address of the gateway
system if applicable. Press Enter to continue.
The configuration is then committed to the switch firmware.
8. You are then prompted either to make the IP address changes active now or at
the next reboot. Enter y at the prompt to have the IP address changes take
effect immediately.
Displaying Devices within the Fabric
To verify that you have fabric-wide connectivity when you install a new switch,
display the fabric-wide device count from the newly installed switch. Use these
steps to display the fabric.
1. Log in to the switch as the admin user.
2. At the command line, issue the nsAllShow command.
This command displays all the connected devices in the fabric.