Hewlett-Packard AdvanceStack 10Base-T Quick Setup Manual
Download Quick setup manual of HP AdvanceStack 10Base-T Switch for Free or View it Online on All-Guides.com.
1
2
3
4
Quick Setup Guide
for the HP AdvanceStack 10Base-T Hubs
Installation details are provided in the HP AdvanceStack 10Base-T Hubs Installation and
Reference Guide (5963-6554).
Install the Hub
1.
Install optional add-in modules, for example an
HP Ethernet SNMP Module into the Expansion
Slot.
2.
Plug the power cord into the hub’s receptacle
and into a properly grounded electrical outlet.
The hub does not have a power switch; it is
powered on when the power cord is plugged in.
HP Ethernet SNMP Module
Power receptacle on
the back of the
hub
Thin LAN
Extension
Distributed Management
RS-232
In Out
85
Reset Exp Slot Security Activity
ThinLAN Console AUI/Xcvr Collision
10Base-T
Hub-12
6
7
129 310 41112
Power
Fault
AdvanceStack HP J2600A
AUI/Xcvr
Slot
ThinLAN
network
port
chain ports RS-232
console port
optional AUI port module
installed in AUI/Xcvr slot
hub status LEDs
and reset button
twisted-pair port LEDs
cable management
guide
power
connector
cover plate over
slot for HP Ethernet SNMP Module
redundant power
connector