Homelite UT32651 Engine Starting Procedure

Download Engine starting procedure of Homelite UT32651 Trimmer for Free or View it Online on All-Guides.com.

Brand: Homelite

Category: Trimmer

Type: Engine starting procedure

Model: Homelite UT32651 , Homelite UT33650

Pages: 2 (1.94 Mb)

Download Homelite UT32651 Engine starting procedure

Homelite UT32651 Engine starting procedure - Page 1
1
Homelite UT32651 Engine starting procedure - Page 2
2
RYOBI ART WORK
Art Part No. : 988000-436 Rev. 001
Where Used : 988000-436
Refer to Drawings for Dimensions.
988000-436
11-24-10 (REV:01)
Make The Most Of Your Purchase!
CALL
1-800-242-4672
www.homelite.com
ENGINE STARTING PROCEDURE
WARNING: This Engine Starting Procedure is not a substitute for reading
the operator’s manual. To reduce the risk of injury, user must read and under-
stand operator’s manual before using this product.
Material: 60lb. Stock Paper.
Color: Orange Yellow.
FRONT
For any questions about operating or maintaining your product, call the Homelite Help Line!
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are available in your operator's manual.
Go to www.homelite.com and register your new tool on-line.
To register your Homelite
®
product by regular mail, please print the following information on a 3"x5" card or standard postcard: your name,
mailing address, phone numbers, email address, Homelite
®
product(s) purchased with item number from package, and serial number for
each product. Mail the card to: Homelite Consumer Products, Attn. Homelite
®
Registration, 1428 Pearman Dairy Road, Anderson, SC 29625.
To receive information on our company and products, please include the following statement on your registration card: "Send me
information on your products and company using the contact information I am providing with this product registration."
®
1
Set to " HALF CHOKE ".
50:1 Ratio = Mix 2.6 oz 2-cycle oil with
1 gallon of fresh gasoline in separate gas
container. SHAKE. Pour into fuel tank.
Slowly press the PRIMER BULB 10x.
Set to "FULL CHOKE".
SQUEEZE THROTTLE TRIGGER FULLY and pull
starter grip until engine runs (no more than 6x).
NOTE: If engine does not start, return to step 3 and repeat.
SQUEEZE THROTTLE TRIGGER FULLY and pull
starter grip sharply until engine attempts
to run (no more than 4x).
1 GALLON
GAS
2
3
4
5
6
7
Allow engine to run 10 seconds, set to " RUN ".
10x
FULL
CHOKE
HALF
CHOKE
RUN
2.6
oz.
6
4
1
3
5
7
2
PRESS and HOLD STOP SWITCH until
engine stops.
To Stop:
8
8