Honeywell MF08CESWW Owner's Manual
Download Owner's manual of Honeywell MF08CESWW Air Conditioner for Free or View it Online on All-Guides.com.
Brand: Honeywell
Category: Air Conditioner
Type: Owner's manual for Honeywell MF08CESWW
Pages: 20 (2.05 Mb)
15
TROUBLESHOOTING GUIDE
Will not run and
water full indicator
light is ON
•
No electricity.
•
Batteries in the remote control need
to be replaced
• The power cord is not properly
plugged in.
•
The safety GFI plug has tripped.
• The thermostat temperature setting
is too close to room temperature.
• Air outlet is blocked.
• There are tight bends in the air
exhaust hose.
• A door or window is open.
•
Clean the air filter
• The exhaust hose is detached.
•
The air filter is dirty.
• Temperature setting is too high.
• Air outlet or intake is blocked.
• Excess water condensation inside
the tank.
• Check for power.
• Change remote control batteries.
• Remove and reconnect the power
cord.
• Reset the safety GFI plug, if
problem persists contact our
customer support.
• Drain the water through the drain
plug (Refer page 14, Water
Condensation Draingage).
The air conditioning
unit does not start
Problem Possible Cause
Solution
Runs a short while
only
Runs but no cooling
• Lower the set temperature.
• Make sure the exhaust hose is
properly connected.
• Connect exhaust hose as per
instructions on page 9.
• Make sure the windows and door
are closed.
• Reinstall exhaust hose properly
(Refer page 9, Installation)
• Reduce temperature setting on
control panel.
• Remove blockage.
The following troubleshooting guide addresses the most common problems. If problems
persist, call customer service. Unplug and disconnect the appliance from the power
source before attempting to troubleshoot.