Honeywell Tradeline T7300F series 2000 Installation Instructions Manual
Download Installation instructions manual of Honeywell Tradeline T7300F series 2000 Thermostat for Free or View it Online on All-Guides.com.
Brand: Honeywell
Category: Thermostat
Type: Installation instructions manual for Honeywell Tradeline T7300F series 2000
Pages: 12 (0.49 Mb)
Download Honeywell Tradeline T7300F series 2000 Installation instructions manual
1
2
3
4
5
6
7
8
9
10
11
12
® U.S. Registered Trademark
© 1998 Honeywell International Inc. • • All Rights Reserved
INSTALLATION INSTRUCTIONS
62 012 3
62-0125—3
T7300F Series 2000 Commercial
Microelectronic Conventional
or Heat Pump Thermostat
APPLICATION
The T7300F Thermostat provides electronic control of 24
Vac commercial single zone heating, ventilating and air
conditioning (HVAC) equipment. When used with a
Q7300A,G,L Subbase, the thermostat is automatically
configured for conventional heat/cool applications. When
used with a Q7300H Subbase, the thermostat is configured
for conventional or heat pump applications, depending on
subbase model. When used with a Q7300C,D Subbase,
the thermostat is automatically configured for heat pump
applications. The T7300F is also field configurable for
automatic or manual changeover between heating and
cooling. The system and fan selections are made by
keyboard entry. All T7300F Thermostats require a common
wire to supply power.
RECYCLE NOTICE
If this control is replacing a control that contains
mercury in a sealed tube, do not place your old
control in the trash.
Contact your local waste management authority
for instructions regarding recycling and the
proper disposal of the old thermostat.
INSTALLATION
When Installing this Product…
1. Read these instructions carefully. Failure to follow
the instructions can damage the product or cause
a hazardous condition.
2. Check the ratings given in the instructions and on
the product to make sure the product is suitable for
your application.
3. Installer must be a trained, experienced service
technician.
4. After completing installation, use these instructions
to check out the product operation.
Mount Thermostat on Subbase
The thermostat mounts on the subbase after it is
installed.
1. Engage tabs at the top of thermostat and subbase.
See Fig. 1.
2. Press lower edge of case to latch.
NOTE: To remove the thermostat from the wall, first pull
out at the bottom of the thermostat; then
remove the top.
Fig. 1. Mount thermostat on subbase.
SETTINGS
Using Thermostat Keys
The thermostat keys are used to:
• set current time and day,
• program times and setpoints for heating and cooling,
• override the program temperatures,
• display present setting,
• set system and fan operation,
• configure Installer Setup,
• check Installer System Test
See Fig. 2 for key information.
M4824A
B. PRESS LOWER EDGE OF CASE TO LATCH.
A. ENGAGE TABS AT TOP OF THERMOSTAT AND SUBBASE OR WALLPLATE.