Hotpoint BD62 Mk2 Instructions For Installation And Use Manual
Download Instructions for installation and use manual of Hotpoint BD52 Mk2 Oven for Free or View it Online on All-Guides.com. This version of Hotpoint BD52 Mk2 Manual compatible with such list of devices, as: BD52 Mk2, BD62 Mk2, DE47X1, DQ47 Mk2
Brand: Hotpoint
Category: Oven
Type: Instructions for installation and use manual
Model: Hotpoint BD52 Mk2 , Hotpoint BD62 Mk2 , Hotpoint DE47X1 , Hotpoint DQ47 Mk2
Pages: 48 (0.88 Mb)
Download Hotpoint BD52 Mk2 Instructions for installation and use manual
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
40
Care and Cleaning (DQ47 & DE47X1)
CLEANING THE DOORS
Take particular care not to damage the inner surface of the door inner glass that is
coated with a heat reflective layer. Do not use scouring pads, or abrasive powder,
which will scratch the glass.
Ensure that the glass panel is not subjected to any sharp mechanical blows.
Stubborn stains can be removed by using a fine steel wool soap pad.
For slight soiling the
inner glass panel may be cleaned, while still warm, without removing it from the door. After
cleaning, rinse and dry with a soft cloth.
DROP DOWN DOORS
Remove the door inner glass as follows.
1. Open the door fully and remove the extrusion top filler cap. (This should be done
by removing both screws, one on each side of the door - see below pic, then
simply lift the inner glass out of position).
NOTE: If you need to use a tool - be careful not to damage the extrusion or end cap.
2. Carefully slide the inner glass towards you and
withdraw it from its locating slots. Ensure
that the door is not allowed to slam shut, due
to the reduction in door weight.
Clean the glass as described above.
3. The inside of the outer door glass can now be
cleaned while still fitted to the cooker.
NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN POSITION.
Refit the door inner glass as follows.
1. Open the door fully.
2. Locate the inner door glass into its slots. The inner door glass has a special
reflective coating on one side, in order to minimise surface temperatures and
energy consumption during use, it is important it is fitted correctly.
3. Carefully slide the glass into its slots as far as it will go and replace the top
filler cap.
Top filler cap
Remove two screws, to
remove top filler cap