HP PSC 2210 Start Here
Download Setup poster of HP 2210 All in One Printer, Laptop for Free or View it Online on All-Guides.com.
Brand: HP
Category: All in One Printer , Laptop , Monitor
Type: Setup poster
Model: HP 2210 , HP PSC 2210v , HP PSC 2210xi
Pages: 2 (2.84 Mb)
1
2
12
9
6
3
12
9
6
3
1
2
1
START HERE
Windows desktop
Turn your PC on and wait for the Windows
desktop to appear.
Close any open programs, including virus-
checking programs.
2
Attach the cover
Insert the two bottom tabs of the
cover into the slots on the unit.
Tilt the cover down and press firmly.
Make sure the tabs lock into place
and the cover is even with the unit.
4
Remove output tray and load paper
Use blank white paper to
prepare for print alignment.
Connect the phone cord to wall jack
5
6
Connect the power cord and USB cable
7
Turn on your HP PSC
8
Insert and align the print cartridges
9
Finish software setup
Remove the bright pink tape
from the print cartridges. Do not
touch the gold-colored contacts
or retape the cartridges.
Make sure both latches
are locked into position.
Close the door.
Make sure the Device Setup complete
screen appears. If you do not see this
screen, check the reference guide for
troubleshooting setup. The software may
prompt you to restart.
Lift the print carriage door up
until it catches. Wait for the
print carriage to move to the
center. Lift the blue and gray
latches.
Pull the end of the gray latch toward
you, press down until it stops, and then
release. Make sure the latch catches
below the bottom tabs. Repeat with
blue latch.
Press Enter to begin alignment.
After a page prints, alignment is
complete. Discard or recycle this
page.
a
b
Make sure you are using the
correct side of the poster.
Turn power On and wait for display
prompt.
Note: See the reference guide for
adjusting the display viewing angle.
Hold the black print cartridge with the label
on top as shown. Slide the cartridge into the
right (gray latch) side of the print carriage.
Hold the color print cartridge with the label on
top as shown. Slide the cartridge into the left
(blue latch) side of the print carriage.
f
g
a
a
b
Make sure you have completed
steps 1 and 2 before this step.
a
latches
a
Make sure to remove any
packing material from inside the
unit
b
c
d
d
e
e
f
g
www.officejetsupport.com
Copyright Hewlett-Packard Company 2002
Printed in USA
10
Set up faxing
Make sure your PC is on.
Follow the onscreen instructions to enter your
name, phone number, and other important
settings. See the reference guide for more
details.
Take the Product Tour to learn about your new
HP PSC.
a
b
c
Windows setup poster
hp psc 2200 series all-in-one
a
c
d
e
f
g
3
Windows users: Follow the steps in order. Do not
connect the USB cable until instructed to do so.
See your box for exact contents and system
requirements.
Insert the HP PSC software CD.
Follow the onscreen instructions.
When prompted to set up your
device, go to step 3.
c
Install the software first
a
b
Black label (56)
Color label (57)
To wall jack
To phone/
modem/
office equipment
Notes:
If nothing appears on your computer screen after
inserting the CD, go to the Windows task bar, click
Start, and then choose Run. In the Run dialog box
type d:\setup.exe (d= your PC's CD ROM drive
letter).
You may see the minimum requirements screen first.
1
2