The HP Officejet 5600 All-in-One series devices have been designed to work with the
Distinctive Alert Faxability Service in New Zealand. However, in order to work, the
Answer Ring Pattern for these devices must be set to Single Rings. The Single Rings option
has been specifically designed to work with the Distinctive Alert Faxability Service. You
can change this setting from the control panel.
To change the answer ring pattern from the control panel
1
Verify that your HP All-in-One is set to answer fax calls automatically. For
information, see the User Guide that came with your device.
2 Press Setup.
3 Press 5, then press 1.
4 Press!until Single Rings appears.
5 Press OK.
Additional notice
1
This equipment shall not be set to make automatic calls to the Telecom ‘111’
Emergency Service.
2 This equipment should not be used under any circumstances which may constitute a
nuisance to other Telecom customers.
3 A Telepermit for any terminal equipment indicates only that Telecom accepts that the
item complies with minimum conditions for connection to its network. It indicates no
endorsement of the device by Telecom, nor does it provide any sort of warranty.
Above all, it does not assure that any item will work correctly with another item of
Telepermitted equipment of a different make or model, nor does it imply that any
device is compatible with all of Telecom’s network services.
4 Decadic (or pulse) dialing is not supported on this device.
5 This equipment is not capable, under all operating conditions, of correct operation
at the higher speeds for which it is designed. Telecom will accept no responsibility
should difficulties arise in such circumstances. This condition typically applies to 56
kbits per second modems and facsimile machines operating at greater than 14.4
kbits per second.
6 Not all telephones will respond to incoming ringing when connected to the
extension socket.
7 This device only responds to Distinctive Alerts DA1, DA2, and DA4.
8 When receiving a DA4 (Faxability) ring signal, setting the Rings to Answer to less
than 3 will result in destroyed Caller ID information if a Caller ID device is connected
to the same line. For information on setting the Rings to Answer, see the User Guide
that came with your HP All-in-One.
9 This equipment may not provide for the effective handover of a call to another device
connected to the same line.
Distinctive alert
faxability service
© 2005 Hewlett-Packard Development Company, L.P.
All rights reserved.
*Q7311-90101*
*Q7311-90101*
Q7311-90101
Printed in [country]
