HP DeskJet 300 series Technical Support Information
Download Technical support information of Dell DeskJet 300 series All in One Printer, Calculator for Free or View it Online on All-Guides.com.
Category: All in One Printer , Calculator , Desktop , Digital Camera , Printer , Switch
Type: Technical support information
Model: Dell DeskJet 300 series , HP Deskjet 320 , HP DeskJet 300 series
Pages: 202 (2.22 Mb)
Download Dell DeskJet 300 series Technical support information
2-14 Installation and Configuration
2. The older model C2614A of the HP DeskJet Portable printer has “Chg Pen” instead of “Change Cartridge”, and “Settings” instead
of “Setup”, written on the printer’s front panel.
Battery level gauge
– The pointer on the print cartridge cradle in Menu mode
skips
the battery level
gauge if no battery pack is installed in the printer.
– If the printer cannot determine the charge level of a newly-installed battery pack,
the carriage will point to the
1
/
4
level mark on the gauge.
– Note that the pointer will show the battery charge level only once, when it first
enters Menu mode, provided a battery pack is installed in the printer. To see the
battery level gauge indication again, after you have made printer settings
selections, you must first
exit
Menu mode, then re-enter it.
– The battery level can also be determined by using the printer self-test or by
running the DJPMenu configuration utility
1
from the computer.
1. The HP DeskJet Portable printer does not have the DJPMenu configuration utility included with the printer; to get this
software, see “Obtaining Printer Drivers” in chapter 7, Service and Support Information. For more information on DJPMenu,
see “Additional Configuration Options with the DJPMenu Configuration Utility” later in this chapter.
Table 2-6. Troubleshooting Common Printer Settings Problems
Problem Possible Cause
Printer does not save
printer settings
1. The Select (LF/FF) button was not pressed after selecting a printer setting.
2. The printer was not in Menu mode. The Menu light must be blinking to change the
printer settings.
3. The user is exiting from Menu mode (pressing the Exit button) without having
pressed the Select button.
4. A software application is overriding the printer setting. Read the documentation
included with the software application for information on specifying printer settings
within the software application.
Pointer will not point to a
setting or a group of settings
1. If the Change Cartridge
2
light is blinking instead of the Menu light, the printer is in the
change cartridge mode instead of Menu mode. Press the Setup
2
button to exit the
change cartridge mode. Then press and hold the Setup button until the Menu light
blinks.
2. The left and right arrow (Font and Draft) buttons move the pointer to the settings
within
a group only. To move between the printer settings menu groups, use the
Menu (Online) button.
3. The printer points to the battery level gauge only if there is a battery pack in the
printer. Similarly, the printer will not point to the BATTERY CONTROL selections
unless there is a battery pack in the printer.
4. With a battery pack in the printer, only one selection is available in the BATTERY
CONTROL group.
– If powered by a power adapter or rapid recharger with a battery pack installed,
only the Quick Charge selection is available.
– If powered by a battery pack, only the Discharge selection is available.
5. The pointer will show the battery charge level
only once
, when it first enters Menu
mode, provided a battery pack is installed in the printer. To see the battery level
gauge indication again, after you have made configuration selections, you must first
exit
Menu mode, then re-enter it.
Table 2-5. Additional Printer Settings Information (Continued)
Topic Information