Audio Note Conquest Silver Installation

Download Installation of Audio Note Conquest Silver Amplifier for Free or View it Online on All-Guides.com.

Brand: Audio Note

Category: Amplifier

Type: Installation for Audio Note Conquest Silver

Pages: 4 (0.02 Mb)

Download Audio Note Conquest Silver Installation

Audio Note Conquest Silver Installation - Page 1
1
Audio Note Conquest Silver Installation - Page 2
2
Audio Note Conquest Silver Installation - Page 3
3
Audio Note Conquest Silver Installation - Page 4
4
July 05
1
Congratulations and thank you for your purchase of the Audio Note Conquest Silver
mono power amplifiers. The Conquest Silver is a pure class A parallel singled ended
valve amplifiers that uses the highly regarded 300B directly heated triode valve. The
Conquest Silver produces a level of performance that is radically superior to current
designs and was specifically designed for sonic performance rather than technical
specifications. It also fulfills all Level 3 criteria.
-Pure Class A operation.
-Zero negative feedback.
-Single ended output stage.
-Valve rectification.
-Directly heated Triode.
-Materials and component quality.
This Level 3 amplifier features MBH output transformer cores, Audio Note copper and
Silver wiring, 1W Tantalum resistors and Audio Note copper foil capacitors.
UNPACKING AND INSTALLATION
These amplifiers are shipped without the valves installed. It is necessary to install
the valves first. It is essential that the valves are installed correctly or serious
damage that is not covered by the warranty will result. We recommend that your
dealer does this for you.
Installing the valves
Please take care when unpacking the amplifiers as they are fairly heavy and place on a
suitable clean space (table or floor) it is recommend that you store the packaging
materials in case the unit requires shipping at a later date.
Carefully unwrap all the valves. You will find 1x 6SN7WGTA, 2 x 300B and 1x 5U4G
valves for each amplifier.
Looking from the front of the amplifier, the first valve to insert is the 6SN7WGTA valve
which goes into the first valve base at the front of the amplifier.
Inspect the locating pin on the bottom center of the valve and align with the valve base
(the locating pin can only go in one way round due to a locating spigot) and with gentle
but firm pressure insert the valve.
Looking from the front of the amplifier, the next valve to plug in is the 5U4G valve
which goes into the last valve base at the back of the amplifier.