HP 250C Service Manual
Download Service manual of HP 250C Plotter, Printer for Free or View it Online on All-Guides.com.
Error + Fast + Load Media: Problems in movement in the XĆaxis (media axis)
The possible causes could be: D Something is causing too much friction in the
X-axis. D Paper jam.
Error + Load Media + Normal: Error in XĆaxis calibration
Did you load media in correct orientation? D Are the marks visible on the
plot? If not, check cartridges. D Are cartridges correctly aligned? If so, the
problem may be in the electronics module, media motor or driveĆroller gear;
if alignment is incorrect, the problem may be in the carriage. There could
also be a problem with the line sensor.
Paper + Cartridges + Error + Normal: Electrical error
The possible causes could be: D Missing or badly seated cartridge. D One
end of the trailing cable is not connected or is badly connected, or the trailing
cable is faulty. D Faulty fan, or fan is disconnected. D Faulty carriage PCA.
D Faulty electronics module.
For more precise troubleshooting ' page 8Ć19, w System Errors.
Paper + Error + Film + Fast: Not enough memory for the sensor data
structure.
D Turn the plotter off, and then on again to see if the problem disappears.
D If the problem remains, consult recent service notes for a possible solution.
D If no service note deals with this error, report the problem to your HP
Response Center. Note conditions and actions before error occurred. Include
setup sheet and service configuration plot in report.
Paper + Cartridges + Error + Film: Communication broken between the two
processors on the main PCA.
Replace the electronics module.
Paper + Error + Film + Load Media: Problems in the free movement of the
carriage.
The possible causes could be: D Something is causing excessive friction in the
YĆaxis (carriage axis). D The carriage touches the bail as it moves.
See also error code
.
8Ć11 TroubleshootingC4699Ć90000