HP 250C Service Manual
Download Service manual of HP 250C Plotter, Printer for Free or View it Online on All-Guides.com.
Plain + Load Media + Error + Film: Problems in the free movement of the
carriage.
The possible causes could be: D Something is causing excessive friction in the
YĆaxis (carriage axis). D The carriage touches the bail as it moves.
Plain + Load Media + Error + Fast: Error detected in mediaĆaxis servo feedback
loop.
The problem may be with the: D MediaĆmotor encoder cable D Media motor
D Electronics module.
Plain + Error + Film + Ready: Failure of Centronics READ.
Firmware error or faulty electronics module.
Plain + Error + Fast + Roll: Communication broken between the two
processors on the main PCA.
Replace the electronics module.
Error + Ready + Roll: Library Error.
Special firmware error. See .
Plain + Error +Film + Normal: Electrical error
The possible causes could be: D Missing or badly seated cartridge. D One
end of the trailing cable is not connected or is badly connected, or the trailing
cable is faulty. D Faulty fan, or fan is disconnected. D Faulty carriage PCA.
D Faulty main PCA.
Plain + Error + Film + Fast: Not enough memory for the sensor data structure.
D Turn the plotter off, and then on again to see if the problem disappears.
D If the problem remains, consult recent service notes for a possible solution.
D If no service note deals with this error, report the problem to your HP
Response Center. Note conditions and actions before error occurred. Include
setup sheet and service configuration plot in report.
8Ć17 TroubleshootingC4699Ć90000